Folded
Tab
Folded
End
Short Seat Belts
21 | Rear Fenders | |
|
|
|
•Fit the rear fenders under the tabs the sides of the seat, as shown.
19
Note: Make sure the fasteners on both short seat belts face each other.
•Fit the folded end of each short seat belt down through the outer slots in the seat. Do not insert the folded tab into the slot. Pull up on each seat belt to make sure it is secure.
22
DO NOT insert screws here.
Folded | Fastener | Fastener | |
| Tab Folded | ||
| Tab | Side | Side |
20 |
| Long Seat Belt | |
|
|
|
|
Note: Make sure the fasteners on the long seat belt are facing the fasteners on the short seat belts.
•Insert the ends of the long seat belt up through the slots in the center of the seat.
•Fit the folded tabs on the belt up through the slots in the center of the seat to keep the long seat belt in place. Make sure the folded tabs are on visible on the top side of the seat.
•Insert two #8 x ¾" screws into the upper hole in each side of the seat and tighten.
Note: Do not insert screws into the lower holes on the seat in this step. These screws will be assembled in this location in step 24.
Seat
Vehicle Frame
23 | FRONT VIEW |
| |
|
|
|
|
• Fit the seat onto the vehicle frame.
13 |