Fisher-Price B3002, B0323 instruction sheet Swinging, To on

Page 14

Swinging

IMPORTANT! The maximum weight limit for this product is 24 lbs. If your child weighs less than 24 lbs., but is really active and appears to be able to climb out of the swing, immediately discontinue its use.

 

Hint: The swing will operate without use of

 

the remote. Simply slide the power switch

Dome

to on .

Dome

Hint: Make sure the dome on the remote and the dome on the swing are within 20 feet of each other, in a direct line and free of obstacles.

Power L.E.D.

Slide the power switch to on . The power LED lights (and then blinks) and the swing begins swinging.

If you do not use the remote, this swing continues swinging until the power switch is turned off . When using with the remote, press the top of the button once to turn swinging off. Press the top of the button again to turn swinging back on.

Hint: The swing will swing up to eight hours after the top of button on the remote is pushed. After eight

hours, you will need to slide the power switch off and then back on again .

When the swing is not in use, slide the power switch to off .

Turn the speed dial to select any of five settings.

Hint: As with most battery-powered swings, a heavier child reduces the amount of swinging motion on all settings. In most cases, the low setting works best for a smaller child while the high setting works best for a larger child.

If you'd like music along with swinging, slide the switch to for music highest volume; for music high volume or for music low volume. When using with the remote, press the bottom of the button once to turn music off. Press the bottom of the button again to turn music back on.

When the swing is not in use turn music off by sliding the switch to .

Hint: Music will be on for up to eight hours after thebottom of the button is pushed. After eight hours,

you will need to slide the power switch off and then back on again.

14

Image 14
Contents Quick Response Swing Model Number B0323, B3002Consumer Information Parts Assembly Push to snap the top of the remote under the holder clips Set the frame assembly aside for Assembly step Fit the grooves on the bracket to the seat tubes, as shown Press to snap the seat wire caps into place Frame Hub Push Button Swing Tube Front Seat Curved Base Fit the toy bar plugs into the sockets on the swing tubes Battery Installation Battery TipsTo loosen the restraint Securing Your ChildTo tighten the restraint Tray Adjusting the SeatUpright, Semi-Recline or Recline To adjust the seat angle Swinging To onTo replace the pad Storage CareTo remove the pad For Best Results FCC Statement United States Only