Fisher-Price B0323, B3002 Fit the grooves on the bracket to the seat tubes, as shown

Page 7

Assembly

M4 Lock Nut
Rounded Side
		Bracket
		Grooves
Shown Actual Size		Tall
		Tall
		End
Lock Nut	Seat
Lock Nut	Tubes	Bottom
		Edge of
		Seat
Hexagonal
Opening

13

•Position the bracket so that the tall end is toward the bottom edge of the seat.

Hint: The M4 lock nuts have been assembled to the bracket at the factory. During shipment of this product, they may have fallen out. Check to be sure there is a lock nut in each hexagonal opening on the bracket. If one (or more) has fallen out, fit the lock nut into a hexagonal opening in the bracket. Make sure the rounded side of the lock nut is facing up.

• Fit the grooves on the bracket to the seat tubes, as shown.

Seat Tubes

Bracket

14

M4 Screw - 4

Shown Actual Size

• Insert four M4 screws through the seat tubes, bracket and into the lock nuts.

•Tighten the screws with a Phillips screwdriver. Do not over-tighten.

Seat

Tubes

15

• Rotate the seat tubes down.

Seat Wire

Bracket Slot

16

• Fit the seat wire through the slot in the bracket as shown.

7

Image 7

Contents Model Number B0323, B3002 Quick Response SwingConsumer Information Parts Assembly Push to snap the top of the remote under the holder clips Set the frame assembly aside for Assembly step Fit the grooves on the bracket to the seat tubes, as shown Press to snap the seat wire caps into place Frame Hub Push Button Swing Tube Front Seat Curved Base Fit the toy bar plugs into the sockets on the swing tubes Battery Tips Battery InstallationTo tighten the restraint Securing Your ChildTo loosen the restraint Upright, Semi-Recline or Recline To adjust the seat angle Adjusting the SeatTray To on SwingingTo remove the pad Storage CareTo replace the pad FCC Statement United States Only For Best Results