Fisher-Price B0323, B3002 instruction sheet Frame Hub Push Button Swing Tube Front Seat Curved Base

Page 9

Seat Bottom

Assembly

Frame Hub

Push

Button

Swing

Tube

Front

of Seat

Curved

21 Front

Base

•Position the seat assembly so that the front of the seat is toward the curved front base.

•While pressing the buttons on the swing tubes, insert them into the frame hubs. Push the swing tubes up until the buttons “snap” into the hole in the frame hubs.

•Push down on the seat to be sure the seat is secured in both frame hubs.

Frame

Hubs

22

#8 x 11/4” Screw - 2

Shown Actual Size

•Insert a #8 x 11/4" screw through each frame hub and into the swing tubes. Tighten the screws with a Phillips screw- driver. Do not over-tighten.

•Again, push down on the seat to be sure the seat is secured to both frame hubs.

Slot

Pad

Slot

Waist Belts

23

•Fit the pocket on the back of the pad onto the seat back.

•Fit the waist belts through the smaller slots in the pad.

Pad

Elastic

Loops

Crotch

Belt

Holes

24

• Lift the bottom of the pad.

•Insert the pad elastic loops through the holes in the seat bottom.

•Insert the crotch belt through the slot in the pad.

•From under the seat, fit the elastic loops onto the tabs on the seat bottom.

9

Image 9

Contents Model Number B0323, B3002 Quick Response SwingConsumer Information Parts Assembly Push to snap the top of the remote under the holder clips Set the frame assembly aside for Assembly step Fit the grooves on the bracket to the seat tubes, as shown Press to snap the seat wire caps into place Frame Hub Push Button Swing Tube Front Seat Curved Base Fit the toy bar plugs into the sockets on the swing tubes Battery Tips Battery InstallationSecuring Your Child To tighten the restraintTo loosen the restraint Adjusting the Seat Upright, Semi-Recline or Recline To adjust the seat angleTray To on SwingingStorage Care To remove the padTo replace the pad FCC Statement United States Only For Best Results