Fisher-Price B3002, B0323 instruction sheet Assembly

Page 4

Assembly

IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts.

 

Front Legs

 

(Longer)

Tapered End

 

 

Press

 

Button

 

Press

 

Button

 

Tapered End

1

Front Base

Remote

Holder

Ribbon

3

Place the front base on a flat surface.

Position a front leg (longer) so that the tapered end is downward, as shown.

While pressing the button on one of the front legs, insert it into the front base. Push down on the front leg until the button “snaps” into the hole in the front base.

Repeat this procedure to assemble the other front leg to the front base.

Pull Up

Front Legs

Pull Up

2

Front Base

 

While standing on the front base, pull the front legs up. The front legs should remain secured to the front base. If you can remove the front legs, you have not assembled them correctly to the front base. Reread and repeat assembly step 1.

4

Using scissors, remove the ribbon connecting the remote and the holder.

Holder

Front

Leg Hole

 

M4 Lock Nut

 

Rounded

 

Side

 

Shown Actual Size

 

Hexagonal Opening

4

M4 Lock Nut

 

(Rounded

 

Side Out)

Position the holder so that the open end faces forward, as shown.

Slide the holder onto the front leg with a hole.

Hint: An M4 lock nut has been assembled to the holder at

the factory. During shipment of this product, it may have fallen out. Check to be sure there is a lock nut in the hexagonal opening on the holder. If it has fallen out, fit the lock nut back into the hexagonal opening. Make sure the rounded side of the lock nut faces out.

Image 4
Contents Quick Response Swing Model Number B0323, B3002Consumer Information Parts Assembly Push to snap the top of the remote under the holder clips Set the frame assembly aside for Assembly step Fit the grooves on the bracket to the seat tubes, as shown Press to snap the seat wire caps into place Frame Hub Push Button Swing Tube Front Seat Curved Base Fit the toy bar plugs into the sockets on the swing tubes Battery Installation Battery TipsTo tighten the restraint Securing Your ChildTo loosen the restraint Upright, Semi-Recline or Recline To adjust the seat angle Adjusting the SeatTray Swinging To onTo remove the pad Storage CareTo replace the pad For Best Results FCC Statement United States Only