Safeline Sit'n'Stroll manual Forward Facing

Page 10

Metal

Hooks

Chest

Clip

Adjuster

Latch

Plates

Crotch

Buckle

4.To move the straps to the proper slot position, loosen the harness adjuster. At the back of the Sit’n’Stroll™ remove the shoulder belts from the metal hooks. Pull the shoulder belts from the front of the seat and place back through the desired slots. Reattach the shoulder belts to the metal hooks. Be sure the belts lay flat against the back of the seat shell. If they are over the stroller conversion handle you will not be able to convert the Sit’n’Strol™ to stroller mode.

5.Ensure the belts are not twisted.

6.Click the latch plates into the buckle. Pull up on both latch plates to ensure they are securely fastened.

7.Snap the chest clip back together. Slide the chest clip so it is at your child’s armpit level. If your child is smaller, you may need to remove the shoulder pads to fully tighten the harness and ensure proper placement of the chest clip.

8.Pull on the belt over the child’s left leg to snug the harness. This belt goes under the seat and attaches to the right lap and shoulder belts.

Tighten the harness by pulling the adjuster belt. The harness should be tight enough for you to only get one finger between the shoulder belt and your child.

9.To loosen the harness, squeeze the adjuster top and bottom and pull up.

Forward Facing

Proper adjustment of the harness system for use forward-facing

1. Open the buckle by pressing the red button and pulling the latch plates from

Latch Plates

Crotch

RedBuckle

Button

the buckle. Open the chest clip.

2.Place your child into the seat, making sure their bottom is fully against the base of the seat.

3.The shoulder straps should fit through the shoulder belt slots, which are at or above the

8

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Page Page Limited Six Month Warranty Table of Contents International Patents and DescriptionsGet to Know Your Sit’n’Stroll For children who weigh Less than 28 poundsSafetyGuidelines Important Notes Page Proper adjustment of the harness system for use rear-facing Rear FacingForward Facing Shoulder Belt Slots Choosing an AppropriateVehicle Seat Location Seethedrawingsbelowforfurtherclarification CorrectPositionInstalling the Sit’n’Stroll in the Vehicle Automatic passive Seat Belts Lap Shoulder Belts with Sewn Latch PlatesManually Adjusted Lap Belts and Locking Latch Plates Switchable Retractors Switchable retractorInstalling the Sit’n’Stroll in theVehicle Forward-FacingAutomatic passive Seat Belts Lap Shoulder Belts with Sewn Latch Plates Be sure the vehicle seat belts are not twisted Page Installing theTopTether with the Sit’n’Stroll Rear Facing TopTether InformationInstalling the Sit’n’Stroll on an Aircraft Converting the Sit’n’Stroll fr om Car Seat to StrollerHandle Slot Slider Grip Operating the Sit’n’Stroll Brakes Converting the Sit’n’Stroll fr om Stroller to Car Seat 3.4Attaching the Sunshade Sit’n’Stroll SunshadeRemoving the Sunshade Tips Installing the Harness Removing the HarnessWashing the Cover and Harness Maintenance and CareReplacement Parts Washing the ShellVehicle Manufacturer Contact Telephone Numbers and Websites
Top Page Image Contents