Safeline Sit'n'Stroll manual Installing the Sit’n’Stroll in theVehicle, Forward-Facing

Page 17

4.Thread the locking clip onto both belts , placing it as close to the latch plate as possible.

5.Buckle the belt again. It may be necessary to press the Sit’n’Stroll™ into the auto seat cushion to get it buckled.

6.Secure the top tether to the tether anchor in the vehicle if desired.

7.Be sure the back of the Sit’n’Stroll™ is at a 45-degree angle. The base of the seat should be horizontal. Use a tightly rolled towel or sheet (or the top tether if it is being used) to adjust the angle of the seat if necessary.

8.Lift up on the Sit’n’Stroll™ to check that it is securely tightened. The belt should be tight around the restraint. If it is not, remove the locking clip and repeat steps 1-6. If you have tightened the belt and it is still not secure, move it to another seating location and repeat steps 1-7. If there is no location in your vehicle that will securely hold the restraint, do not use it! Contact your vehicle dealer to have a vehicle belt installed that will remain tight.

Installing the Sit’n’Stroll™ in theVehicle

Forward-Facing

The Sit’n’Stroll™ is equipped with two belt paths for use forward facing. The path best suited for your child is determined by their height and weight.

♦If your child is taller than 33 inches and weighs over 28 pounds, the vehicle seat belt should be secured in the upper forward-facing vehicle belt path.

♦If your child is under 33 inches and weighs less than 28 pounds, the vehicle seat belt should be secured in the lower forward-facing vehicle belt path.

Use the vehicle belt path based upon your child’s height and weight.

If, after installing the Sit’n’Stroll™ , it is not tight enough, move it to another seating location. If it still cannot be secured tightly, contact your vehicle dealer and request that a manual seat belt system be installed.

15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Page Page Limited Six Month Warranty International Patents and Descriptions Table of ContentsFor children who weigh Less than 28 pounds Get to Know Your Sit’n’StrollSafetyGuidelines Important Notes Page Rear Facing Proper adjustment of the harness system for use rear-facingForward Facing Shoulder Belt Slots Seethedrawingsbelowforfurtherclarification CorrectPosition Choosing an AppropriateVehicle Seat LocationInstalling the Sit’n’Stroll in the Vehicle Lap Shoulder Belts with Sewn Latch Plates Automatic passive Seat BeltsManually Adjusted Lap Belts and Locking Latch Plates Switchable retractor Switchable RetractorsForward-Facing Installing the Sit’n’Stroll in theVehicleAutomatic passive Seat Belts Lap Shoulder Belts with Sewn Latch Plates Be sure the vehicle seat belts are not twisted Page TopTether Information Installing theTopTether with the Sit’n’Stroll Rear FacingConverting the Sit’n’Stroll fr om Car Seat to Stroller Installing the Sit’n’Stroll on an AircraftHandle Slot Slider Grip Operating the Sit’n’Stroll Brakes 3.4 Converting the Sit’n’Stroll fr om Stroller to Car SeatRemoving the Sunshade Sit’n’Stroll SunshadeAttaching the Sunshade Tips Removing the Harness Installing the HarnessReplacement Parts Maintenance and CareWashing the Cover and Harness Washing the ShellVehicle Manufacturer Contact Telephone Numbers and Websites
Top Page Image Contents