Safeline Sit'n'Stroll manual Manually Adjusted Lap Belts and Locking Latch Plates

Page 15

Manually Adjusted Lap Belts and Locking Latch Plates

Rear-Facing Tabs

1.Place the Sit’n’Stroll™ in a rear facing position in the car.

2.Thread the lap belt through the rear facing vehicle-belt tabs. Click the latch plate into the buckle.

3.Push down firmly on the Sit’n’Stroll™ to sink it into the car’s seat cushion, while pulling on the end of the lap belt or shoulder part of the lap/shoulder belt. You may have to press on one armrest at a time to get the auto belt tight. Pull the seat belt as tight as possible across the unit.

4.Be sure the back of the Sit’n’Stroll™ is at a

45-degree angle. The base of the seat should be horizontal. Use a tightly rolled towel or sheet under the seat base to adjust the angle if necessary.

5.Secure the top tether to the tether anchor in the vehicle if desired.

6.Lift up on the Sit’n’Stroll™ to check that it is securely tightened. If it moves away from the auto seat, retighten the auto seat belts.

7.If you have tightened the belt and it is still not secure, move it to another seating location and repeat steps 1-6. If there is no location in your vehicle that will securely hold the restraint, do not use it! Contact you vehicle dealer to have a vehicle belt installed that will remain tight.

Be sure the car seat belts are not twisted.

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Page Page Limited Six Month Warranty International Patents and Descriptions Table of ContentsFor children who weigh Less than 28 pounds Get to Know Your Sit’n’StrollSafetyGuidelines Important Notes Page Rear Facing Proper adjustment of the harness system for use rear-facingForward Facing Shoulder Belt Slots Seethedrawingsbelowforfurtherclarification CorrectPosition Choosing an AppropriateVehicle Seat LocationInstalling the Sit’n’Stroll in the Vehicle Lap Shoulder Belts with Sewn Latch Plates Automatic passive Seat BeltsManually Adjusted Lap Belts and Locking Latch Plates Switchable retractor Switchable RetractorsForward-Facing Installing the Sit’n’Stroll in theVehicleAutomatic passive Seat Belts Lap Shoulder Belts with Sewn Latch Plates Be sure the vehicle seat belts are not twisted Page TopTether Information Installing theTopTether with the Sit’n’Stroll Rear FacingConverting the Sit’n’Stroll fr om Car Seat to Stroller Installing the Sit’n’Stroll on an AircraftHandle Slot Slider Grip Operating the Sit’n’Stroll Brakes 3.4 Converting the Sit’n’Stroll fr om Stroller to Car SeatSit’n’Stroll Sunshade Attaching the SunshadeRemoving the Sunshade Tips Removing the Harness Installing the HarnessWashing the Shell Maintenance and CareReplacement Parts Washing the Cover and HarnessVehicle Manufacturer Contact Telephone Numbers and Websites
Top Page Image Contents