Switchable Retractors
This type of seat belt system stays loose during normal driving. However, they have special retractors which allow use with child restraints. Read your vehicle owner’s manual and look for a label on the vehicle seat belt. Note: Not all vehicle belts with switchable retractors have instructions for securing child restraints on the vehicle belt.
1.Pull the vehicle belt all the way out.
2.Follow steps
3.Check to ensure the vehicle belt is securely locked by pulling slowly on the shoulder portion of the belt. It should remain locked. If it is not locked, allow the car seat belt to fully retract and repeat.
Lap/Shoulder Belt with Buckle Tongue that
Slides Freely Along Seat Belt Webbing
Free sliding lap/shoulder belts have a free sliding latch plate that does not lock to the belt.When placing the Sit’n’Stroll™ in seating positions equipped with this system, you must use a locking clip to prevent the seatbelt from slipping, unless it has a
switchable retractor.
1.Place the vehicle lap belt over the Sit’n’Stroll™ and position it through the rear facing vehicle- belt tabs. Click the latch plate into the buckle.
2.Push down firmly on the Sit’n’Stroll™ to sink it into the car’s seat cushion, while pulling on the shoulder part of the lap/shoulder belt. You may have to press on one armrest at a time to get the auto belt tight. Pull the seat belt as tight as possible across the unit.
3.Hold the lap and shoulder belts together behind the latch plate . Unbuckle the belt while holding the belts together.
14