Fisher-Price 71592 manual Weak reception Out of range or insufficient signal

PROBLEMS AND SOLUTIONS

PROBLEM	PROBABLE CAUSE	SOLUTION
Weak reception	Out of range or insufficient signal	Test reception by moving the transmitter and/or receiver to different locations
		throughout the house. Relocate the transmitter and/or receiver.
	AC adaptor cord(s) not fully extended	Fully extend AC adaptor cord(s).
	Improper antenna position	Make sure antennas are pointing upward.
Receiver variable lights	Weak or dead battery in receiver	Replace the battery in the receiver with a fresh 9V alkaline battery or
display does not light		use the AC adaptor.
Interference	Signal interference due to another	Change channel switch on both transmitter and receiver to the other channel.
(buzzing, static, etc.)	nursery monitor or cordless
and signal indicator on	telephone, etc.
receiver is ON
	Channel switches not on same	Set channel switch on transmitter and receiver to the same channel.
	setting (channel)
Interference	Signal interference due to other	Change channel switch on both transmitter and receiver to the to the
(buzzing, static, etc.)	nursery monitors or cordless	other channel.
and signal indicator on	telephones, etc.
		Identify and eliminate source of interference. Do not use more than one
receiver is OFF
		transmitter at the same time in the same house.
	Channel switches not on same	Set channel switch on transmitter and receiver to the same channel.
	setting (channel)
	Receiver power is ON but transmitter	Make sure the transmitter is ON. The power indicator should be lit.
	power is OFF
	Code switches in receiver and	Reset code switches in receiver and transmitter so that they match.
	transmitter do not match
Interference	Signal interference due to another	Make sure transmitter power is ON.
(garbled voices) and	Fisher-Price®Direct Link Privacy Monitor™
		Change channel switch on both transmitter and receiver to the other channel.
signal indicator on
receiver is ON
		We recommend “Checking Privacy” periodically. See page 6.
Feedback	Receiver is too close to the transmitter	Move receiver further away from transmitter.
(squealing or whistling)
	Volume is set too high	Lower volume on the receiver.
All five bars on the	Receiver power is ON but	Turn the transmitter power ON.
receiver variable lights	transmitter power is OFF
display light
	Out of range or insufficient signal	Move the receiver closer to the transmitter.
	Channel switches not on same	Set channel switches on transmitter and receiver to the same channel.
	setting (channel)
	AC adaptor not properly connected	Check AC adaptor jack-to-socket and plug-to-outlet connections.
	to transmitter

11