Fisher-Price 71592 manual Sound Reception, Resetting Your Scrambled Code

SOUND RECEPTION

It is very important to test the sound reception of the Direct Link Privacy Monitor™ before first-time use

and whenever you change the location of the transmitter.

•Test the Direct Link Privacy Monitor™ transmission and reception. Have an adult speak into the transmitter in the room you intend to use the transmitter. (If an adult is not available, use a ticking clock or radio.) Place the receiver in the room in which you intend to use the receiver. Adjust the receiver location or volume dial until you hear sounds clearly through the receiver.

•If you experience interference (buzzing, static, etc.) while using one channel setting, switch both units to the other channel. Selecting a channel is usually a one-time adjustment.

•If interference occurs on both channels or if further problems develop, please refer to the Problems and Solutions Guide beginning on page 10.

RESETTING YOUR SCRAMBLED CODE

Code

Switches

5

4

3

2

1

	YL
	NO	CD
			V9	Battery
1	2 3 4 5
				Compartment
				Door

TRANSMITTER

•Check to be sure the channel switch on both the receiver and the transmitter are on the same channel.

•Locate the battery compartment doors on the back of the receiver and the transmitter.

•Push the battery compartment doors in the direction of the arrow to open them.

•If you are using battery power in either unit, remove the batteries.

•Using a pen, push the code switches up or down to change your scrambled code. Make sure the code switches in the

transmitter and receiver match.

	4	5
3
2
1

Battery
Compartment	ONLY	DC
Door			9V

Code

Switches

1 2 3 4 5

RECEIVER

IMPORTANT!

-Do not use a pencil to move the code switches.

-Do not position all five code switches in the OFF (down) position. When the code switches in the transmitter are all in the OFF (down) position, the scrambling feature is disabled.

•If you are using battery power in either unit, re-install the batteries.

•Slide the power switches on the front of the transmitter and receiver to the ON position. The power indicators light.

•Check to be sure the signal indicator on the receiver lights. If the signal indicator on the receiver does not light, you have not reset the code switches correctly. Please re-read this section

carefully and reset the code switches.

8