
Operating Instructions
Custom Program
1)Select from the eight existing [Custom] programs and it will instantly play.
2)Enter the [Edit] section to create or edit program.
3)You can create or edit up to 100 scenes. To program less than 100 scenes, set the [Step time] of the scene after your last scene to 0.
4)Select the ID address of the target unit. Setting ID address to 0 selects all units in the serial link. Color/Effects combination for different IDs is allowed.
5)Specify the [Module] or modules to run active.
Note: this option is intended for use with the COLORado 3; for the COLORado 1, it will function as if [Module] is set to one.
0 = 1,2,3
1 = 1
2 = 2
3 = 3
4 = 1,2
5 = 2,3
6 = 1,3
6)RGB mix using the [Red], [Green] and [Blue] functions and adjusting the range between 0 and 255.
7)Select a [Strobe] speed from
8)Select the [Step time] for the current scene. Step time unit values
Range 0 – 10 = | 0.1sec per unit |
Range 11 – 255 = | 1 sec per unit |
9)Set a [Fade time] for the current scene in one second increments from 0 to 255.
Play Schedule
Simply activate this menu [Play schedule] to run.
Clock
[Clock] [Time now]: To view the current time on the controller.
[Clock] [Edit now]: Edit the time and date.
Schedule
There are 24 Wash, Effect and Custom programs that can be set with Start and End times. Start times take priority over End times. Programs will not overlap. Programs with the most recent Start time will always override the existing previously executed program.
Settings
[DMX address]
This function sets the DMX address for the controller. It is addressable from 1 to 250.
[Range]
Enter the number of fixtures connected in series.
[Allow edit]
This function either enables or disables editing in Wash, Effect and Custom programs.
[Detect device]
This is the manual method of detecting and connecting the controller to all new units in series. It is
COLORado™ 3P User Manual | 30 | 3/17/2009 9:54 AM |