Sanyo MOV-112S Routine Maintenance, Cleaning of unit, Cleaning the inside, Cleaning the frame

Page 19

ROUTINE MAINTENANCE

LWARNING

Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in

order to prevent electric shock or injury.

Ensure you do not inhale or consume medication or aerosols from around the unit at the time of maintenance. These may be harmful to your health.

CAUTION

Always put on dry gloves to protect hands at the time of maintenance. Failure to use gloves may result in cuts or abrasions from any sharp edges or corners.

Note:

Never attempt to directly spray water on the heater box or the inside of the oven as it is very dangerous. In addition, never use volatile or combustible chemicals to clean the inside.

Cleaning of unit

Cleaning the inside

Remove all racks from the inside.

Clean the inside using a soft cloth damped with neutral detergent. Afterwards, wipe off with a cloth washed in clean water.

Remove the separation plate at the bottom of the oven and wipe off any particles in the heater box, using a soft cloth damped with water.

Cleaning the frame

Clean the frame using a soft cloth damped with neutral detergent. Afterwards, wipe it up the detergent with a wet cloth.

Cleaning the rack

To clean the rack, place it in a tub of warm water mixed with neutral detergent and wipe with a sponge or a soft cloth. Racks subject to high temperature will naturally become colored. This is a natural coloration, acknowledge this.

18

Image 19
Contents MOV-112S MOV-212S Contents Precautions for Safe Operation Precautions for Safe Operation \WARNING Precautions for Safe Operation Environmental Conditions Sterilizer Components Sterilizer Components Control panel and keypad Location with a sturdy and level floor InstallationInstallation site Location away from heat generating sourcesBefore Commencing Operation InstallationPrerunning Operating Instructions Basic operating flow chart of control panelSterilization Timer functionStable running Press the power key Stable running with delay timeStart of operation with no change of setting Chamber temperature 50C, Delay time 1 hourSterilization with timer mode Alarms & Safety Functions Cleaning the frame Routine MaintenanceCleaning of unit Cleaning the insideDisposal of Unit Trouble ShootingKey operation is disabled If the alarm function operatesPerformance SpecificationsSafety check sheet