Disassembly
1.Remove any panel which might be on the Lift. Release the Brake Arm (30) and crank the Winch Handle (34) to lower the Cradle (41) all the way down.
2.Slide the Cradle Outriggers (44) all the way in until they latch. Fold up the Panel Support Hooks (62).
3.Press the Spring Tab on the underside, and remove the crossarms by sliding them out of the tapered socket.
4.Unlock the Cradle Latch (47). Raise the Cradle to re- move it from the Frame.
5.Rotate the Winch Wheel one full revolution forward to raise the inner telescoping section.
6.Unlock the Winch Assembly by lifting the Slide Bar (22) with one hand, and rotating the Slide Bar Lock coun- terclockwise with your other hand.
7.Hold the Slide Bar Lock (23) in this disengaged posi- tion, and press down on the telescoping sections of the frame with your other hand. The Winch Assembly (20) will rotate toward the Frame Housing (11).
8.Crank the telescoping sections all the way down. Swing up the Retaining Hook (26) and crank the telescoping sections back up until they are secured by the hook.
9.Hold the Retaining Hook in position while rotating the Winch Forward.The Winch Assembly will fold up against
the Frame. When the Slide Bar contacts the Frame, tighten the cable by turning the wheel further to hold the Winch Assembly in this position.
10.Lift the Frame and Winch Assembly to remove it from the Base.
11.To fold the Base, press down on the Slide Yoke Ring (5) and pivot the Outer Legs (3) forward until they lock into place in closed position.
SKU 95852 | For technical questions, please call | Page 11 |