Set Up Legs and Extend the Backstop
1.Unlatch the two Outer Legs (3) by pressing down on the Slide Yoke Ring (5).
2.Rotate the Outer Legs into position.
3.Be sure the SlideYoke Ring snaps into the hole on the under- side of the Slide Tube, locking the Outer Legs into position.
4.Rotate the Backstop (7) downward. Be sure the Backstop wedges against the floor, holding the Lift in place.
Extend the Outriggers
1.The Outriggers (44) can be extended to support the ends of panels. For safe use, both outriggers should be extended the same amount to support the panel equally. Warning! Failure to properly extend the outriggers could cause the Hoist to tip over, resulting in personal injury and/or property damage.
2.To extend an Outrigger, pull out the Lock Pin (43) to release it, and pull the Outrigger straight out the end of the Body Cradle (42).
3.The Lock Pin (43) will lock the Outrigger in three positions, while fully retracted, while extended 21” or fully extended at 33”. Be sure the Lock Pin is engaged in one of these positions whenever using the Lift.
4.Extend both Outriggers equally, and ensure that both are locked in place using the Lock Pin.
5.To avoid damage, always retract the outriggers before transporting or storing the Lift.
Open the Panel Support Hooks
1.Rotate the Panel Support Hooks (62) on the lower ends of the Crossarms (61) outward. These must be in place during use to safely support the
panel.
2.Always rotate the Support Hooks into their closed position when transporting or storing the Lift, to avoid damaging the Hooks.
Slide Bar Lock
1.The Slide Bar Lock (23) holds the Winch Assembly (20) in its fully extended operating position.
2.Follow instructions on Page 5, item 4 of this manual for engaging and releasing the Slide Bar Lock.
3.NOTE: Do not tighten the nut on the Slide Bar Lock.You will not be able to fold up the unit for transport or storage.
SKU 95852 | For technical questions, please call | Page |