INSTALLATION | MTM5400 Mobile Terminal Installation Manual | 33 |
|
|
|
Installation Procedure
1.Select either the transmission hump or an open underneath portion of the dash to mount your terminal (see Figure 6). When mounting the trunnion on the transmission hump, be careful that the transmission housing is not affected.
2.Use the trunnion mounting bracket as a template, to mark the hole positions on the mounting surface. Use the innermost three holes for a curved mounting surface, such as the transmission hump, and the three outermost holes for a flat surface such as under the dash.
3.
4.Secure the trunnion mounting bracket to the mounting surface with the three
5.Slide the terminal into the trunnion. Secure the terminal with the two wing screws provided.
The keypad labelling of the control head may vary according to the specific customer/country concerns.
6.Ground the radio housing to the nearest vehicle chassis ground point, which can be done by removing the paint from the trunnion where the radio and vehicle chassis touches the trunnion, or use a short cable with ring lugs in both end and connect this to chassis under wingscrew.