INSTALLATION | MTM5400 Mobile Terminal Installation Manual | 61 |
|
|
|
Re-crimp Procedure
In order to use accessories (RLN4858 and GKN6272) with the rear connector of the radio, please follow the
These accessories do not require to be
1.Cut and remove nickel plated pins from wire.
2.Strip the insulation from the end of the wires (2mm to 4mm).
3.Place the new gold plated crimp pin (from the PMLN5072 kit) on the gauge slot on the crimp tool.
4.Insert wire into wire slot of the crimp pin.
5.Apply pressure to the crimp tool handle, until wire is crimped by the pin.