Summit ENG. 4358-3412E instruction manual Forward-Facing Use

Page 13

4358-3412E Summit 3/2/07 2:55 PM Page 25

4

Position locking clip about 1 in. (2.5 cm) from vehicle belt’s buckle plate.

Forward-Facing Use

Forward-Facing Use: 22-40 lbs. (10.

5

Rebuckle belt. Lap belt

 

portion should now be

 

tight. If not, remove

 

locking clip and repeat all

 

steps.

Lap/Shoulder Belt

Lap Belt

Refer to the “Choosing Restraint and Position” section to make sure your child is at the proper weight and height to face forward.

LATCH Belt

!WARNING:

Using this child restraint in any vehicle seat where the lap or LATCH belts cannot be tightened securely and properly or where it can be loosened by pulling on it can result in serious injury or death.

Check vehicle instructions for more information about air bag/child restraint use.

1-18 kg), 34-43” (85.1-110 cm), Over 1 year of age.

22

23

Image 13
Contents Merchandise Total Part Cost Quantity Total CostShipping and handling Sales TaxBefore You Begin Table of Contents4358-3412E Summit 3/2/07 255 PM Registration and Recall Information Aircraft InstallationUnderstanding Your Vehicle Seat Buckles Air Bag Seat Bight Where seat cushions meetAnchor Bracket Latch AnchorsChild Restraint Parts Preparing Child Restraint to Fit Your Child Choosing Restraint and PositionLbs 10.1-18 kg 34-43 in .1-110 cm and Over 1 Year Old Forward-Facing Adjust BuckleSecuring Your Child in the Child Restraint Reclining the Child RestraintRotating Armrests Belt-Positioning Booster Must be fully- upright Removing Your Child From the Child Restraint Knowing Your Vehicle Belts Choosing Latch or Vehicle BeltsVehicle belt too short Manual Belts Locking ClipForward-Facing Use Forward-Facing Installation with Vehicle Belts Forward-Facing InstallationBack, and from side to Path, tilt and pushSide. If the seat belts do Not loosen, your childLoosen, your child Latch belts do notRestraint should be SecureTo Adjust Top Anchorage Adjusting the Top Anchorage StrapAnchorage Strap Put knee To child restraintBelt-Positioning Booster Use To Adjust TopAnchorage Strap Removal of Harness Belt-Positioning Booster Installation Reinstall Harness Reinstall HarnessBack of shell Removing Seat Pad for CleaningFrom back of shell, release the elastic straps shown in red Installation Tips TroubleshootingMake sure harness guides tabs go over metal bar Replacement Parts Order Form WarrantyLimitation of Damages