Summit ENG. 4358-3412E instruction manual Belt-Positioning Booster Installation

4358-3412E Summit 3/2/07 2:55 PM Page 39

Belt-Positioning Booster

Installation

1	Child restraint must be in
	the full upright position.
	Pull out on recline handle
	and pull child restraint all
	the way up.

Place booster seat against the back of the vehicle seat.Tuck the top anchorage hook and splitter plate under the base. Have child sit in seat with his back and bottom fully in the seat.

3	Secure the vehicle
	shoulder belt through the
	notch in the shoulder belt
	guide.The belt should
	cross the base of the
	child's neck and across
	the chest (not the face or
	neck). Pull up on the

vehicle shoulder belt to tighten.

Check periodically to ensure your child has not moved out of position and loosened the vehicle shoulder belt.

4	To adjust shoulder belt
	guide, pull down on red
	end and slide guide up
	and down track. Make
	sure the belt guide locks
	into place.

Belt-Positioning Booster Use: 40-100 lbs. (18.1-45.4 kg),

2

Place BOTH shoulder and lap belt across child’s thighs. Lock buckle.

NOTE: Make sure the lap and shoulder belt are placed under armrest as shown.

!WARNING

Check vehicle instructions for more information about air bag/child restraint use.

Do Not Use only the lap belt when using this seat as a belt-positioning booster without the internal harness.

The shoulder belt must always be adjusted snugly across the child’s chest.

43-52” (110.1-132.1 cm), Over 1

!WARNING

Use only the vehicle’s lap and shoulder belt system when restraining the child in this booster seat. Failure to do this can result in serious injury or death.

NEVER place the shoulder belt under the child’s arms.

Use only the vehicle’s lap and shoulder belt system when restraining the child

in this booster seat.

Failure to follow these warnings can result in serious injury or death to your child.

year of age.

36 37