4358-3412E Summit 3/2/07 2:55 PM Page 15
5 | Place the child’s bottom |
and back flat against the | |
| child restraint.This will |
| increase comfort and |
| allow the harness to |
| properly tighten. |
8 |
Squeeze the metal bar on the back of the seat. Move harness/headrest adjuster up or down to the position that correctly fits your child. Release bar into slot to lock.
NOTE: The highest position is for belt- positioning use only.
6 | Adjust Buckle: |
Determine which of the | |
| three available buckle |
| slots is both comfortable |
| and snug. Refer to |
| “Removal of Harness” to |
| adjust buckle. |
7 | Check Harness Height |
| |
Harness |
|
Guide | Position: Harness guide |
| must be even with or |
| just above the shoulders. |
If the harness is below the child’s shoulders with the headrest in the 3rd highest position, the child weighs at least 40 lbs. (18.1 kg) and is over 1 year old, convert the seat to a
!WARNING:
Make sure metal bar is locked into position. Failure to do this can result in serious injury or death.
Harness Covers (on select models): Harness covers help provide comfort to the neck. For Harness Covers to fit correctly, you may have to fit the upper ends of the covers through the harness slots. To remove the covers, unthread the harness from harness bracket (see belt- positioning booster section), remove covers, and rethread harness. Reverse to replace insert.
12 | 13 |