Summit ENG. 4358-3412E Path, tilt and push, Back, and from side to, Side. If the seat belts do

4358-3412E Summit	3/2/07	2:55 PM	Page 29
4		With weakest hand at belt
		path, tilt and push the
		child restraint forward and
		back, and from side to

Forward-Facing Installation with LATCH Belt: Install LATCH Belts

Forward-

side. If the seat belts do

not loosen, your child

restraint should be secure.

NOTE: Some “play” from

front to back or about an

inch from side to side is

acceptable. If it moves

more, review “Knowing

Your Vehicle Belts” and

“The Locking Clip”

sections.

!WARNING

Using this child restraint in any vehicle seat where the lap belt cannot be tightened securely and properly or where it can be loosened by pulling on it can result in serious injury or death.

5	After checking for hot
	seat and buckles, place
	your child in the child
	restraint as described in
	the “Securing Your Child in
	the Child Restraint”
	section.

1

2

3

NOTE: Do not use LATCH system along with the adult lap or lap/shoulder belt.

Route LATCH belt through upper slot in side of shell.

Pull one LATCH hook across the back and out the other side.

The LATCH adjuster can be on either side, but the belt should not be twisted.

Connect and tighten harness straps prior to installing in vehicle.

Place child restraint flush against the back of the vehicle seat forward- facing in the back seat.

The recline position is to be used only to install the child restraint flush against the back of the vehicle seat back, if needed.

Facing Use: 22-40 lbs. (10.1-18 kg), 34-43” (85.1-110 cm), Over 1 year of age.

26 27 continued on next page.