4358-3412E Summit 3/2/07 2:55 PM Page 31
4 |
Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight. Repeat for other side of child restraint. See your vehicle owner’s manual for locations and more information.
Place one knee in the child restraint and push down firmly while pulling up on the loop to tighten belt.
7 | With weakest hand at | |
belt path, tilt and push | ||
| ||
| the child restraint | |
| forward and back, and | |
| from side to side. If the | |
| LATCH belts do not | |
| loosen, your child | |
| restraint should be | |
| secure. |
NOTE: Some “play” from front to back or about an inch from side to side is acceptable.
If the child restraint does not remain tight, do not use the child restraint in this seating location with this LATCH system.
!WARNING
LATCH hooks MUST be securely fastened. Failure to do this can result in serious injury or death.
6 |
With knee still in child restraint, attach hook to anchor in vehicle. Push down firmly and tighten top anchorage strap.
To adjust top anchorage strap: See “Adjusting Top Anchorage Strap” section.
8 |
After checking for hot seat and buckles, place your child in the child restraint as described in the “Securing Your Child in the Child Restraint” section.
To release LATCH:
Remove child from child restraint. Press down firmly on adjuster side of child restraint and press release button to release tension. Unhook LATCH from bar by squeezing spring lever and twist hook off bar.
.1-110 cm), Over 1 year of age.
28 | 29 |