Baby Trend E30FL0211U To remove the base from the vehicle, Squeeze the webbing release button

7.0INSTALLATION

1.Locate a LATCH seating position as identified in your vehicle owner’s manual. Some LATCH seating positions may require deploying of anchors, or installation of guides.

2.Remove the Safety Seat from the base by squeezing the base release handle located under the center of the foot end of the

Safety Seat and lifting upward on the Safety Seat. (Fig. 25-1)

7.0INSTALLATION

place. Check that there is no slack in the webbing on both sides of the base and that the base is tightly installed. Fig. 45-2 and 45-3.

6. Check that nothing is on top of the base or

anything that will interfere with the proper

latching of the Safety Seat to the Base. Place

3.Remove the LATCH connectors from their storage position inside the base

(Fig. 44-1). Place the Base in the rear- facing position in a forward facing vehicle seat as shown in Fig. 45-1. The Child must face the rear of the vehicle and Safety Seat must be placed in a vehicle seat that faces forward.

4.Locate the LATCH anchors in the vehicle seat. (Fig. 44-2) Once located, snap the

Safety Seat LATCH connectors onto the steel rod. Listen for the click and check that both connectors are firmly attached to the anchor rods by pulling outward on the connectors. (Fig. 45-2)

5.Proper installation of the Base requires that the LATCH webbing be very tight. To tighten the webbing, push down hard with your knee or hand on the Base while pulling upward on each webbing end. The webbing will automatically lock in

Fig. 44-1

Latch Anchor

Fig. 44-2

the Safety Seat onto the Base and push down

until the Safety Seat latches securely to the

Base and you hear a click. Pull upward on

the Safety Seat to check that the Safety Seat

is securely latched onto the base. (Fig. 25-1)

If the Safety Seat does not securely latch

onto the Base, the Safety Seat will provide

No Protection for your child. DO NOT use

the Safety Seat with the Base if it does not

securely latch onto the Base. Please call

Baby Trend at 1-800-328-7363 for assistance.

7. To remove the base from the vehicle,

squeeze the webbing release button

on the LATCH connector to loosen the

webbing. (Fig. 46-1a) Please note

that the LATCH connector can not be

released from the LATCH anchor if the

webbing is tight. Press the LATCH

hook release button on each

connector to release the connector

from the anchor. (Fig. 46-1b)

Snap onto anchors

Fig. 45-1

Fig. 45-2

Fig. 45-3

44 45