Baby Trend E30FL0211U manual Attaching the Canopy, Adjustment of the Shoulder Straps, Or crash

Page 15

5.0 FEATURES

5.0FEATURES

5.8 Attaching the Canopy

Slip the canopy stays through the sleeves on the canopy.

The canopy is attached by inserting the ends of the canopy plastic stays into the female fittings found on the inside of the handle hub.

5.9 Adjustment of the Shoulder Straps

WARNING

Failure to properly adjust the harness on your child increases the risk of death or serious injury in the event of a sharp turn, sudden stop or crash. Please follow the instructions very closely to ensure that the harness is properly adjusted to fit your child at all times. Your child will grow very rapidly! Please check the fit of the harness every time you use the Safety Seat.

Adjustable Back Safety Seat

The Adjustable Back Safety Seat includes a sliding back component that will adjust the height of the harness straps as the back is adjusted.

28

To adjust the seat back height, turn the moving back adjuster knob behind the seat clockwise to increase the seat back height and counter clockwise to decrease the seat back height. Each half turn will raise or lower the slots 1/2”.

The proper height of the harness straps is even with or just below your child’s shoulders.

Remove the Safety Seat from the Base and rotate the Carry Handle to the non rocking position. Place your child in the Safety Seat such that your child’s bottom is all the way to the rear and bottom of the seat. (See Fig. 35-2) Rotate the knob behind the seat back to raise or lower the moving seat back and harness straps. Knob must remain in vertical position after adjustment. (Fig. 29-1) The Harness Straps must be even with or just below the child’s shoulders. (Fig. 29-2) DO NOT use the Safety Seat with the Harness adjusted above the child’s shoulders as the child will not be held securely in a sharp turn, sudden stop,

or crash.

Fixed Back Safety Seat

The fixed seat back version of the Safety Seat features three height adjustments for the harness shoulder straps. The harness straps must be used in the slots that position the

Knob handle must

be vertical

Fig. 29-1

Fig. 29-2

29

 

Page 14 Page 16
Image 15
Page 14 Page 16
Contents FLEX-LOC Table of Contents HOW to Register Your Safety Seat Your child’s safety depends onRegister About your child SafetySafety Information Safety StandardsAbout Active Air Bags About an unoccupied Safety Seat About this Safety SeatAbout use as a carrier Safety Selecting the Best Location for the Safety Seat LocationOverall Considerations in Selecting a Location Check that the Vehicle Seat Belt is Safe to Use Location Lap/shoulder combination seat belt with Seat belt Fig5-Point Harness FeaturesSafety Seat Features and Their Proper USE Rear view of Adjustable Back Model Rear View of Fixed Back Model Base Lock Button Use of the Safety Seat with the Base Other Features HarnessLatch Connectors Operation of the Carry Handle Seat Angle IndicatorSeat Angle Adjuster Crotch StrapOr crash Adjustment of the Shoulder StrapsAttaching the Canopy Slip the canopy stays through the sleeves on the canopyTurn the seat over. Locate the Belt Adjuster Adjuster Plate. FigRemove both Harness Straps from the Belt Car seat shell. Pull outward Safety Seat. FigFrom the Safety Seat. Fig Will see the crotch strap anchor clipUsing Infant Restraint Securing your Child in the Safety Seat / CarrierInfant Restraint Installation Securing the Safety Seat or Base in the VehicleFor the 5-Point Harness Preparation Through the Safety Seat without the Base To tighten a lap belt onlySeat. Fig Installation of the Base using Latch To remove the base from the vehicle On the Latch connector to loosenThat the Latch connector can not be Connector to release the connectorSetting Proper Recline of the Safety Seat / Base Final Safety Checks Safety Seat or Base in the VehicleFinal Checks Additional Information Using the Safety Seat in an AirplaneFor care and maintenance see fabric tag ADD’L InformationReplacement Parts
Top Page Image Contents