Britax Boulevard Lap-Belt Installation, Do not install with non-locking ELR, 2-point vehicle belt

Page 18

Installation: Rear Facing

Lap-Belt Installation

Figure A illustrates a typical rear-facing, lap-belt installation.

When not in use, always store LATCH connectors in storage slots. (See page 28).

WARNING!

Do not install with non-locking (ELR), 2-point vehicle belt.

1�Fully recline restraint, then place it rear facing on vehicle seat.

2�Lift cover and open rear-facing lock-off farthest from where vehicle belt will be buckled. (fig. B)

3�Pull vehicle belt out, then pass it through farthest rear-facing belt slot from where vehicle belt will be buckled (fig. C).

The vehicle belt can be routed over or under restraint cover.

4�Route vehicle belt across restraint seat then through second rear-facing belt slot.

5�Verify vehicle belt is not twisted, then buckle (fig. D).

6�Push child restraint firmly into vehicle seat while removing slack from vehicle belt.

7�Position vehicle belt through lock-off arm (fig. E), tighten belt, close lock-off arm and replace cover.

Lock-off is properly closed when a click is heard.

To prevent breakage, never extend lock-off arm beyond its natural open position and always keep lock-off closed when not in use.

A

B

C

16

Image 18
Contents Boulevard Page Table of Contents Death or Serious Injury can occur Page Safety Information Important NotesCertification RegistrationWeight Range Rear-Facing Forward-FacingMaximum Height Rear-Facing Rear-Facing Installation Installation AircraftAircraft Installation Forward-Facing InstallationFeatures Do not discard foam inserts found under the cover Vehicle Safety Belts Vehicle CompatibilityVehicle Seating Positions Vehicle Buckle Position Installation Rear Facing Latch InstallationRemoval Lap/Shoulder Belt Installation Removal Lap-Belt Installation Do not install with non-locking ELR, 2-point vehicle beltInstallation Rear Facing Installation Forward Facing Installation Forward Facing 5Rotate seat into forward-facing position1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Installation Versa-Tether Safety InformationUsing the Versa-Tether See figures B and C for rear-facing installationRear-Facing Tether Connector Strap Rip-Stitch Tether Energy-Absorbing TetherSwitching the Latch Connector Restraint FunctionsStoring the Latch Connector Recline AdjustmentInfant Body Pillow Adjusting the Chest Clip Chest Clip Fastening the Chest ClipReleasing the Chest Clip Harness Buckle Fastening the Harness Buckle Releasing the Harness BuckleHarness Height Securing Your Child Securing Your ChildHarness Height Adjustment Care and Maintenance Cover RemovalRefitting the Cover Cleaning the Harness Cleaning the Cover and PillowsCleaning the Shell Cleaning the Harness AdjusterHarness Buckle Removal Rethreading the Harness BuckleCleaning the Harness Buckle Warranty Limited ONE-YEAR WarrantyPage Page Page