Britax Boulevard manual 1Place child restraint forward facing on vehicle seat

Page 22

Installation: Forward Facing

Lap/Shoulder Belt Installation

Figure A illustrates a typical forward-facing lap/ shoulder-belt installation.

Whennotinuse,alwaysstoreLATCHconnectors in storage slots.

1�Place child restraint forward facing on vehicle seat.

Restraint must be in full upright position when installed in forward-facing mode with children over 33 pounds (15 kg.).

Britax recommends use of Versa-Tether® to improve installation. Remove Versa- Tether from pouch and loosely attach to an approved tether-anchorage point (pg. 24).

2�Pull vehicle belt out, then thread it over LATCH bar and through the forward- facing belt path (fig. B).

3�Verify that vehicle belt is not twisted and is routed over LATCH bars, then buckle (fig. C).

4�Rotate lever downward to open forward-facing lock-off farthest from where vehicle belt will be buckled.

5�Remove slack from lap portion of vehicle belt.

6�Kneel on child restraint to push it into vehicle seat while pulling shoulder portion of vehicle belt tightly through lock-off (fig. D).

A

B

C

20

Image 22
Contents Boulevard Page Table of Contents Death or Serious Injury can occur Page Safety Information Important NotesCertification RegistrationForward-Facing Weight Range Rear-FacingMaximum Height Rear-Facing Rear-Facing Installation Installation AircraftAircraft Installation Forward-Facing InstallationFeatures Do not discard foam inserts found under the cover Vehicle Safety Belts Vehicle CompatibilityVehicle Seating Positions Vehicle Buckle Position Installation Rear Facing Latch InstallationRemoval Lap/Shoulder Belt Installation Removal Lap-Belt Installation Do not install with non-locking ELR, 2-point vehicle beltInstallation Rear Facing Installation Forward Facing Installation Forward Facing 5Rotate seat into forward-facing position1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Installation Versa-Tether Safety InformationUsing the Versa-Tether See figures B and C for rear-facing installationRear-Facing Tether Connector Strap Rip-Stitch Tether Energy-Absorbing TetherSwitching the Latch Connector Restraint FunctionsRecline Adjustment Storing the Latch ConnectorInfant Body Pillow Chest Clip Fastening the Chest Clip Adjusting the Chest ClipReleasing the Chest Clip Releasing the Harness Buckle Harness Buckle Fastening the Harness BuckleHarness Height Securing Your Child Securing Your ChildHarness Height Adjustment Cover Removal Care and MaintenanceRefitting the Cover Cleaning the Harness Cleaning the Cover and PillowsCleaning the Shell Cleaning the Harness AdjusterHarness Buckle Removal Rethreading the Harness BuckleCleaning the Harness Buckle Warranty Limited ONE-YEAR WarrantyPage Page Page