Britax Boulevard manual Using the Versa-Tether, See figures B and C for rear-facing installation

Page 26

Installation: Versa-Tether®

Using the Versa-Tether

1� Consult your vehicle’s owner’s manual for approved tether-anchorage locations.

2� Locate the tether on rear of restraint and place up and over seat back while securing restraint.

3� Secure child restraint by a seat-belt or LATCH system.

4� Press and hold tilt-lock adjuster, then pull to fully extend tether strap into a "V" shape.

5� Locate hook on strap and loosely attach tether to an approved anchor point.

• See figure A for forward- facing installation.

• See figures B and C for rear-facing installation.

NOTE: Rear-facing installation may also require use of Tether Connector Strap, as described on page 25.

6� Pull Versa-Tether strap to remove all slack. Roll up excess webbing and store in tether pouch.

7� Verify there is tension in Versa-Tether strap and that child restraint is properly secured. The restraint is secure when it cannot be moved front-to-back or side-to-side more than 1 inch (2.5 cm.) at belt path. If restraint is not secure, repeat procedure or use an alternate seating location.

A

B

C

24

Image 26
Contents Boulevard Page Table of Contents Death or Serious Injury can occur Page Safety Information Important NotesCertification RegistrationMaximum Height Rear-Facing Weight Range Rear-FacingForward-Facing Rear-Facing Installation Installation AircraftAircraft Installation Forward-Facing InstallationFeatures Do not discard foam inserts found under the cover Vehicle Safety Belts Vehicle CompatibilityVehicle Seating Positions Vehicle Buckle Position Installation Rear Facing Latch InstallationRemoval Lap/Shoulder Belt Installation Removal Lap-Belt Installation Do not install with non-locking ELR, 2-point vehicle beltInstallation Rear Facing Installation Forward Facing Installation Forward Facing 5Rotate seat into forward-facing position1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Installation Versa-Tether Safety InformationUsing the Versa-Tether See figures B and C for rear-facing installationRear-Facing Tether Connector Strap Rip-Stitch Tether Energy-Absorbing TetherSwitching the Latch Connector Restraint FunctionsInfant Body Pillow Storing the Latch ConnectorRecline Adjustment Releasing the Chest Clip Adjusting the Chest ClipChest Clip Fastening the Chest Clip Harness Height Harness Buckle Fastening the Harness BuckleReleasing the Harness Buckle Securing Your Child Securing Your ChildHarness Height Adjustment Refitting the Cover Care and MaintenanceCover Removal Cleaning the Harness Cleaning the Cover and PillowsCleaning the Shell Cleaning the Harness AdjusterHarness Buckle Removal Rethreading the Harness BuckleCleaning the Harness Buckle Warranty Limited ONE-YEAR WarrantyPage Page Page