Britax Boulevard manual Care and Maintenance, Cover Removal, Refitting the Cover

Page 35

Care and Maintenance

Cover Removal

WARNING! Do not take apart or attempt to take apart the harness. It is unnecessary and dangerous to do so.

Never remove the buckle tongues from the harness. They cannot be reattached after removal.

1�Remove infant body pillow.

2�Loosen harness by lifting harness adjuster lever while pulling shoulder straps forward as far as possible.

3�Unhook shoulder straps from yoke on rear of child restraint.

4�Pull upper harness straps through head pad and cover to front of restraint.

5�Remove buckle and belly pad (pg. 35).

6�Gently remove head pad cover. Be careful not to damage the energy-absorbing foam.

7�Remove upper portion of cover.

8�Pull lower harness straps, buckle tongues, HUGS™ pads, and chest clip through lower slots in cover.

9�Remove entire cover from restraint.

Refitting the Cover

To refit the cover, reverse above directions. Make sure that the shoulder straps are threaded through the chest clips and that the harness is not twisted.

33

Image 35
Contents Boulevard Page Table of Contents Death or Serious Injury can occur Page Important Notes Safety InformationRegistration CertificationMaximum Height Rear-Facing Weight Range Rear-FacingForward-Facing Forward-Facing Installation Installation AircraftAircraft Installation Rear-Facing InstallationFeatures Do not discard foam inserts found under the cover Vehicle Compatibility Vehicle Safety BeltsVehicle Seating Positions Vehicle Buckle Position Latch Installation Installation Rear FacingRemoval Lap/Shoulder Belt Installation Removal Do not install with non-locking ELR, 2-point vehicle belt Lap-Belt InstallationInstallation Rear Facing Installation Forward Facing 5Rotate seat into forward-facing position Installation Forward Facing1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Safety Information Installation Versa-TetherSee figures B and C for rear-facing installation Using the Versa-TetherRear-Facing Tether Connector Strap Energy-Absorbing Tether Rip-Stitch TetherRestraint Functions Switching the Latch ConnectorInfant Body Pillow Storing the Latch ConnectorRecline Adjustment Releasing the Chest Clip Adjusting the Chest ClipChest Clip Fastening the Chest Clip Harness Height Harness Buckle Fastening the Harness BuckleReleasing the Harness Buckle Securing Your Child Securing Your ChildHarness Height Adjustment Refitting the Cover Care and MaintenanceCover Removal Cleaning the Harness Adjuster Cleaning the Cover and PillowsCleaning the Shell Cleaning the HarnessRethreading the Harness Buckle Harness Buckle RemovalCleaning the Harness Buckle Limited ONE-YEAR Warranty WarrantyPage Page Page