Britax CS manual Energy-Absorbing Versa-Tether, Child Seat Functions, Recline Adjustment

Installation: Versa-Tether®

Energy-Absorbing Versa-Tether®

The energy-absorbing Versa-Tether was designed to enhance the performance of the child seat tether. By introducing a staged release of the tether webbing, the forward movement of the child seat is delayed while reducing the amount of energy transferred to the child seat during a crash. A secondary benefit of the energy- absorbing Versa-Tether is to help indicate when the child seat has been involved in a moderate or severe crash and replacement of the child seat is necessary.

Figure A shows the tether when the child seat
is acceptable for continued use (provided the
child seat has not been involved in a crash). The
colored stitching will be intact and the webbing
will be looped inside the shell.
Figures B and C show the tether when the child	a
seat is unacceptable for continued use. If any of
the loops have pulled through the back side of the
shell and/or any of the colored stitching has been
released on either side, the child seat is no longer
acceptable for use. Discontinue use of the child
seat.
IMPORTANT: Regardless of whether loops have	b
pulled through the back side of the shell and the
colored stitching has been released, discontinue use
of the child seat if it has been involved in a moderate
or severe crash.
	c

Child Seat Functions

Storing the LATCH Connectors
When the LATCH connector is not in use, lift the cover
to access the LATCH storage slots (Fig. D). Fold the
LATCH adjuster and the connector, then slide each
set into the adjacent slot.
NOTE: Child seats are shipped from Britax with the	D
LATCH connectors in the storage slots. You will have
to open the rear-facing lock-offs to remove the LATCH
connectors from storage.
Recline Adjustment
Pull the recline handle (Fig. E) then slide the child	E
seat shell into the desired position. Release the
recline handle, then verify the child seat has locked
into position.

WARNING!

•This child seat must be in the recline position when installed rear-facing.

•Child seat must be in full upright position when installed forward-facing with children who weigh more than 15 kg (33 lbs) optional only for rear-facing use.

NOTE: It will be necessary to loosen the tether, vehicle seat belt, and/or LATCH strap before adjusting the recline position. The tether, vehicle seat belt, and/or LATCH strap must be properly re-tightened after adjusting the recline position.

28 29