Britax CS manual Double Check Car Seat-to-Vehicle Installation

Page 23

IMPORTANT:

�DOUBLE CHECK EVERY TIME YOU USE THIS CAR SEAT.

Double Check Car Seat-to-Vehicle Installation:

�Check that the LATCH or vehicle seat belts connections to the vehicle are tight and locked.

�Verify the car seat cannot be moved front-to-back or side-to-side more than one inch (2.5 cm) at the connection point.

Double Check Child-to-Car Seat Installation:

�Tug on the buckle to ensure proper locking.

�Confirm harness straps are snug and over both shoulders and hips. You should not be able to pinch excess harness strap webbing at the child’s shoulder.

�Make sure the chest clip is properly fastened and positioned in the middle of the child’s chest at armpit level.

Britax Child Safety, Inc.

13501 South Ridge Drive

Charlotte, NC 28273

USA

A Britax Childcare Group Limited company

Tel 1.888.427.4829

www.BritaxUSA.com

Image 23

Contents MarathonTM CS Table of Contents Death or Serious Injury can Occur Registration Safety InformationImportant Notes CertificationRear-Facing Important Harness AdjustmentsRear-Facing Forward-FacingDo not discard the foam inserts found under the cover Child Seat FeaturesVehicle Compatibility Incompatible Vehicle BeltsVehicle Buckle Positions Vehicle Seating PositionsAlign each Latch strap on the Latch bar Latch InstallationInstallation Rear-Facing Belt through the open lock-off, tighten belt Lap-Shoulder Belt InstallationVehicle belt, then the shoulder portion Position the shoulder portion of the vehicleVehicle belt can be routed over or under cover Lap-Belt InstallationPlace the child seat forward-facing on the vehicle seat Installation Forward-FacingUpright position Fig, C Designated tether anchor for the chosenSeat is secure Verify that the vehicle belt is not twistedIs routed over the Latch bars, then buckle Off until the vehicle belt is secured Fig. FIf the vehicle Is equipped with a designated Tether anchor While removing slack from the vehicle beltTether anchor if available according to Forward-Facing Installation Safety InformationInstallation Aircraft Rear-Facing InstallationRoute the strap around the fixed vehicle anchor point Using the Versa-TetherTether Connector Strap Child Seat Functions Recline AdjustmentEnergy-Absorbing Versa-Tether Harness Buckle Adjusting Harness Slot HeightChest Clip Slide the Hugs chest pads down towards the buckle Important checklist before tightening the harnessBuckling and Tightening the Harness Securing Your ChildCleaning the Harness Adjuster Cleaning the CoverCleaning the Shell Cleaning the HarnessDo not lubricate, use solvents, abrasive Cleaning the Harness BuckleHarness Buckle Removal Re-threading the Harness BuckleLimited ONE-YEAR Warranty WarrantyPage Double Check Child-to-Car Seat Installation Double Check Car Seat-to-Vehicle Installation

Related manuals

Manual 24 pages 15.69 Kb