Britax CS manual Incompatible Vehicle Belts, Vehicle Buckle Positions, Vehicle Seating Positions

Page 7

Vehicle Compatibility

Incompatible Vehicle Belts

WARNING! The following types of vehicle belts are NOT compatible with this child seat:

Vehicle Compatibility

Vehicle Buckle Positions

WARNING!The position of the vehicle belt buckle can adversely affect the stability of the child seat.

If the buckle lies near the incorrect position () when the vehicle belt is tightened, try fitting the child seat in another seating position in the vehicle OR consult

1 Vehicle belts with top or bottom anchor points on the vehicle door.

3 Lap-shoulder belts that have a separate retractor each for the lap section and shoulder section

2Motorized,automaticvehicle belts

4 Lap belts forward of the vehicle seat bight.

your vehicle owner’s manual to see if you can lower the vehicle buckle position by twisting the vehicle buckle stalk. If it is not possible to achieve the correct position ( ) for the buckle, then another seating position MUST be used.

Vehicle Seating Positions

WARNING! Some vehicles have no seating positions which are compatible with this child seat or any other child seat. If in doubt,

contact the vehicle manufacturer for assistance.

Forward-facing vehicle seats MUST be used with this child seat. Side- facing or rear-facing seats CANNOT be used. See diagram below.

WARNING!

DO NOT place a child seat rear-facing in the front seat of a vehicle with a passenger air bag unless deactivated. DEATH or SERIOUS INJURY can

5 Lap belts that have a retractor that locks only in case of a sudden stop (emergency locking retractor or ELR).

10

occur. See your vehicle owner's manual for child seat installation instruc- tions. The back seat is the safest place for children 12 and under.

11

Image 7
Contents MarathonTM CS Table of Contents Death or Serious Injury can Occur Registration Safety InformationImportant Notes CertificationRear-Facing Important Harness AdjustmentsRear-Facing Forward-FacingDo not discard the foam inserts found under the cover Child Seat FeaturesVehicle Compatibility Incompatible Vehicle BeltsVehicle Buckle Positions Vehicle Seating PositionsInstallation Rear-Facing Latch InstallationAlign each Latch strap on the Latch bar Belt through the open lock-off, tighten belt Lap-Shoulder Belt InstallationVehicle belt, then the shoulder portion Position the shoulder portion of the vehicleVehicle belt can be routed over or under cover Lap-Belt InstallationPlace the child seat forward-facing on the vehicle seat Installation Forward-FacingUpright position Fig, C Designated tether anchor for the chosenSeat is secure Verify that the vehicle belt is not twistedIs routed over the Latch bars, then buckle Off until the vehicle belt is secured Fig. FTether anchor if available according to While removing slack from the vehicle beltIf the vehicle Is equipped with a designated Tether anchor Forward-Facing Installation Safety InformationInstallation Aircraft Rear-Facing InstallationTether Connector Strap Using the Versa-TetherRoute the strap around the fixed vehicle anchor point Energy-Absorbing Versa-Tether Recline AdjustmentChild Seat Functions Chest Clip Adjusting Harness Slot HeightHarness Buckle Slide the Hugs chest pads down towards the buckle Important checklist before tightening the harnessBuckling and Tightening the Harness Securing Your ChildCleaning the Harness Adjuster Cleaning the CoverCleaning the Shell Cleaning the HarnessDo not lubricate, use solvents, abrasive Cleaning the Harness BuckleHarness Buckle Removal Re-threading the Harness BuckleLimited ONE-YEAR Warranty WarrantyPage Double Check Child-to-Car Seat Installation Double Check Car Seat-to-Vehicle Installation
Related manuals
Manual 24 pages 15.69 Kb