Britax CS manual Safety Information, Installation Aircraft, Rear-Facing Installation

Page 14

Installation: Aircraft

This child seat is certified for aircraft use. Most airlines in the U.S. and Canada will allow the use of a child seat as long as it is labeled as an approved child seat for airline use and fits properly on the aircraft seat. Contact the airline about their policy prior to traveling.

The FAA recommends that a child weighing up to 40 pounds (18.1 kg) use a certified, harnessed child seat while traveling on an aircraft.

Install your child seat in a window seat to avoid blocking the aisle.

If the aircraft lap belt is too short, ask the flight attendant for a belt extender.

Rear-Facing Installation

For rear-facing aircraft installation (Fig. A), follow Rear-FacingLap-Belt Installation instructions on pages 16–17.

44To aid installation on aircraft, open the rear- facing lock-offs to allow routing of large buckles.

Forward-Facing Installation

A

For forward-facing aircraft installation (Fig. B),

follow Forward-FacingLap-Belt Installation

 

instructions on pages 22–23.

 

b

Installation: Versa-Tether®

Safety Information

WARNING!

When using the child seat in forward-facing mode, attach the Versa- Tether only to tether anchors designated by the vehicle manufacturer as tether anchorage points. Use of other locations is not approved or permitted.

DO NOT modify the vehicle without advice from the vehicle manufacturer if a tether anchorage is not available.

IMPORTANT:

Britax recommends that the tether be used at all times. Using the tether will improve the stability of the child seat and reduce the risk of injury.

If your vehicle does not currently have a tether anchor attachment, refer to your vehicle owner’s manual or contact the vehicle manufacturer for assistance.

24

25

Image 14
Contents MarathonTM CS Table of Contents Death or Serious Injury can Occur Certification Safety InformationImportant Notes RegistrationForward-Facing Important Harness AdjustmentsRear-Facing Rear-FacingChild Seat Features Do not discard the foam inserts found under the coverVehicle Seating Positions Incompatible Vehicle BeltsVehicle Buckle Positions Vehicle CompatibilityAlign each Latch strap on the Latch bar Latch InstallationInstallation Rear-Facing Position the shoulder portion of the vehicle Lap-Shoulder Belt InstallationVehicle belt, then the shoulder portion Belt through the open lock-off, tighten beltLap-Belt Installation Vehicle belt can be routed over or under coverDesignated tether anchor for the chosen Installation Forward-FacingUpright position Fig, C Place the child seat forward-facing on the vehicle seatOff until the vehicle belt is secured Fig. F Verify that the vehicle belt is not twistedIs routed over the Latch bars, then buckle Seat is secureIf the vehicle Is equipped with a designated Tether anchor While removing slack from the vehicle beltTether anchor if available according to Rear-Facing Installation Safety InformationInstallation Aircraft Forward-Facing InstallationRoute the strap around the fixed vehicle anchor point Using the Versa-TetherTether Connector Strap Child Seat Functions Recline AdjustmentEnergy-Absorbing Versa-Tether Harness Buckle Adjusting Harness Slot HeightChest Clip Securing Your Child Important checklist before tightening the harnessBuckling and Tightening the Harness Slide the Hugs chest pads down towards the buckleCleaning the Harness Cleaning the CoverCleaning the Shell Cleaning the Harness AdjusterRe-threading the Harness Buckle Cleaning the Harness BuckleHarness Buckle Removal Do not lubricate, use solvents, abrasiveWarranty Limited ONE-YEAR WarrantyPage Double Check Car Seat-to-Vehicle Installation Double Check Child-to-Car Seat Installation
Related manuals
Manual 24 pages 15.69 Kb