Installing the Content Switching Module

Catalyst 6000 family switch chassis

Servers that are connected to the Catalyst 6000 family switch through a bridged or a routed connection

Management station that is available through a Telnet or a console connection to perform configuration tasks

Installing the CSM

This section describes how to install the CSM into the Catalyst 6000 family switch.

Note All modules, including the supervisor engine (if you have redundant supervisor engines), support hot swapping. You can add, replace, or remove modules without interrupting the system power or causing other software or interfaces to shut down. For more information about hot-swapping modules, refer to the Catalyst 6000 Family Module Installation Guide.

To install the CSM into the Catalyst 6000 family switch, perform these steps:

Step 1 Make sure you take the necessary precautions to prevent ESD damage.

Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself.

Step 2 Choose a slot for the CSM. See Figure 4 for slot numbers on a Catalyst 6000 family switch.

Note Slot 1 is reserved for the supervisor engine. Slot 2 can contain an additional supervisor engine in case the supervisor engine in slot 1 fails. If a redundant supervisor engine is not required, you can insert the CSM in slots 2 through 9 on a 9-slot chassis, or slots 2 through 6 on the 6-slot chassis, or slots 2 through 13 on the 13-slot chassis.

 

Catalyst 6000 Family Content Switching Module Installation and Configuration Note

12

78-11631-02 Rev. A0

Page 12
Image 12
Cisco Systems 6000 manual Installing the CSM