Cisco Systems 6000 manual Configuration Examples, Single Subnet Bridge Mode Configuration

Configuration Examples

Configuration Examples

Caution All examples assume that the ip slb mode csm command has been entered as described in “Configuring the Content Switching Module” section on page 19.

These examples show how to configure Content Switching in the following configurations:

•Single Subnet (Bridge) Mode Configuration, page 35

•Secure (Router) Mode Configuration, page 37

•Fault-Tolerant Configuration, page 38

•Configuring HSRP, page 43

Single Subnet (Bridge) Mode Configuration

In the single subnet (bridge) mode configuration, the client- and server-side VLANs are on the same subnets. Figure 9 shows how the single subnet (bridge) mode configuration is set up.

Figure 9 Single Subnet (Bridge) Mode Configuration

Client Services Gateway Client-side Server-side 192.158.38.10 192.158.38.10

Virtual server 1 192.158.38.30 Gateway

192.158.38.20

Router A

ClientNAS

workstation router

VLAN 2

Router B

Gateway

192.158.38.21

VLAN 3

Content provider

Server A Server B Server Farm 1

48428

Note The addresses in Figure 9 refer to the steps in the following task table.

	Catalyst 6000 Family Content Switching Module Installation and Configuration Note
78-11631-02 Rev. A0		35