Graco 8486, 8490 manual Airplane Use, Cupholder on certain models

Page 33

8.3 Airplane Use

This restraint is certified for use in Motor Vehicles. It is certified for use in Aircraft ONLY when used with the built-in harness. When used as a booster without the harness, this restraint is NOT certified for use

in aircraft because there is no shoulder belt available.

Important points to remember:

1.Airlines have some restrictions about the use of car seats.

2.Install your car seat on an airplane in the same way it is installed in an automobile with a lap belt (see Section 6.2, Securing the Car Seat in Your Vehicle, pp. 22-23).

3.Check that the airplane seat belt holds the car seat securely in place at all times.

8.4 Cupholder (on certain models)

1.Insert the two prongs of the cupholder into the two slots on either the left or right side of the seat ￿.

2.Push cupholder down until the clip snaps onto the bottom of seat ￿. CHECK that cupholder is secure by pulling on it.

￿

￿

Clip

33

Image 33
Contents Understand the instructions in this manual Car Seat/Booster SeatTable of Contents Properly securing your child in the car seat Your child’s safety depends onRegister Your Car Seat Registration InformationRecall Information If You Need HelpCupholder certain models FeaturesAdjuster Never Leave Your Child Unattended Important InformationPage Height and Weight Limits Without Built-in Harness With Built-in HarnessVehicle Seat Requirements Car Seat LocationVehicle Seat Belt Requirements Unsafe Vehicle Belt SystemsLap Belts with Emergency Combination Lap/Shoulder Belt with Retractor Safe Vehicle Belt Systems For Built-in Harness Only Lap Belts Manually AdjustedCombination Lap/Shoulder Belt with Locking Latch Plate With or Without Built-in HarnessCombination Lap/Shoulder Belt with Sliding Latch Plate Locking clip provided withConnect lap and shoulder belts as shown To Install Locking ClipWith Latch Positioning the Harness Straps Using Car Seat with Built-in HarnessOpen harness clip Place child in the seatIf straps are in the proper slots, go to on Push adjuster bar down Rotate red lock down Reassemble straps onto adjuster bar exactly as shownSee also .3, Securing Your Child in the Car Seat, Harness AdjustmentWith a Vehicle Lap or Lap/shoulder Belt Securing the Car Seat in Your VehicleSafety Check for Secure Installation Tighten vehicle seat beltVehicle belt must stay tight. Car seat must be very tight Thread Latch Never put two Latch connectors on oneHook Latch Belt must lay flat and not be twistedAll Latch seating Positions have tether Safety Check for Secure InstallationCheck that straps are not twisted Securing Your Child in the Car SeatPage Using Car Seat Without Built-in Harness Remove harness straps Harness RemovalFor more help Open chest clip Remove crotch strap. See on page 19 for more helpSecuring Child and Booster Seat in Vehicle Using the Tether Additional informationTighten the tether strap securely Latch storage Storing LatchCupholder on certain models Airplane UseBuckle and Harness Adjuster clean with a damp cloth Care and MaintenanceTo Remove Seat Cover Remove elasticPreceding instructions Replacement Parts How to OrderHarness strap with buckle tongues Latch Model NoAsiento para automóvil/ asiento para niños Uso del asiento para automóvil con el Arnés incorporado Uso del asiento para automóvil sin elInformación adicional Advertencias a padres y otros usuarios La seguridad de su niño depende deSujetar a su niño correctamente en el asiento de seguridad Registre su asiento para automóvil Información sobre el registroInformación sobre el retiro de productos del mercado Por favor, complete la información que se solicitaCaracterísticas Si necesita ayudaApoya vasos ciertos modelos Arnés Conector del la sogaInformación importante AdvertenciasSegún las estadísticas de accidentes, LOS Page Limitaciones de peso y altura SIN el arnés incorporado CON el arnés incorporadoRequisitos del asiento Del vehículo Ubicación del asiento para automóvilRequisitos del cinturón de seguridad del vehículo Sistemas Peligrosos de cinturones de vehículosCinturones de regazo con Está conectada a la placa de seguridad en la otra punta Para el arnés incorporado solamente Sistemas Seguros de cinturones de vehículosDel vehículo Con O sin el arnés incorporadoPara instalar la traba de seguridad Pliegue del Asiento Del vehículo Con LatchUso del asiento para automóvil CON el arnés incorporado Colocación de las correas Del arnésColoque al niño en el asiento Page Gire la traba roja hacia abajo Vea también la Sección 6.3, Asegurar a Ajuste del arnésCon el cinturón del vehículo de regazo o regazo/hombro Asegurar el asiento para automóvil en su vehículoPase el cinturón de seguridad Para el cinturón De regazo solamenteAjuste el cinturón de seguridad del vehículo Verificación de seguridad para una instalación seguraColoque el asiento para Adelante Pase el LatchEl cinturón debe mantenerse en posición plana sin torcerse Verificación de seguridad para una instalación segura No use el asiento para automóvil si el arnés no se traba Asegurar a su niño en el asiento del automóvilPage Si el niño no puede mantener el Uso del asiento para automóvil SIN el arnés incorporadoEliminación del arnés Saque las correas delObtener más ayuda Desabroche el gancho del pecho Asegurar al niño y el asiento para niños en el vehículo Información adicional Uso de la sogaEl arnés Almacenamiento del Latch Uso en aeronaves Apoya vasos En ciertos modelosPuntos importantes que recordar Cuidado y mantenimiento Eliminación del Arnés, páginas Para obtener Ayuda Para sacar la funda del asientoCómo hacer pedidos Piezas de repuestoShip to Enviar a Model No. N de modelo

8490, 8486 specifications

The Graco 8490 and 8486 are highly regarded models in the world of airless paint sprayers, designed to meet the demands of both professionals and DIY enthusiasts. These sprayers stand out due to their exceptional performance, durability, and user-friendly features, making them ideal for a variety of painting projects.

One of the main features of the Graco 8490 is its powerful motor, which is capable of delivering a consistent flow of paint. This ensures a smooth and even application, allowing users to achieve a professional finish with ease. The 8486 model, while slightly less powerful, still provides a reliable performance for lighter projects. Both models boast a high outlet pressure, which enables users to spray thicker materials and achieve better coverage in fewer coats.

The Graco 8490 comes equipped with the SmartControl technology, which ensures a consistent spray fan regardless of the pressure setting. This feature greatly enhances control during the painting process, allowing users to adjust the spray pattern according to their needs. The 8486 model, on the other hand, offers a simplified control system that is easy to operate, making it an excellent choice for those new to airless sprayers.

Durability is another key characteristic of these Graco models. Constructed with high-quality materials, both the 8490 and 8486 are built to withstand the rigors of frequent use. The design incorporates a sturdy frame and features like a built-in carrying handle for added convenience. Additionally, the easy-to-clean design helps maintain the sprayer's functionality over time, reducing the need for extensive maintenance.

Both models also come with Graco's proven RAC (Reverse-A-Clean) tip system, which allows for easy cleaning and quick tip replacement. This feature minimizes downtime and enhances the overall efficiency of the painting process.

In summary, the Graco 8490 and 8486 are exceptional airless paint sprayers that deliver superior performance, durability, and user-friendly features. Their innovative technologies, such as SmartControl and the RAC tip system, make them ideal choices for anyone looking to achieve a flawless paint job, whether for professional or personal projects. With these sprayers, users can expect consistent results and a seamless painting experience.