Adcom GFR-700HD user manual Programming Remote Commands, Programming a Command

Programming Remote Commands

Once you’re familiar with the preprogrammed com- mands, you may wish to program specific buttons on the GFR-700HD remote to control your source com- ponents. To do this, you will need:

•Your source component remote control, which will teach the new command.

•The GFR-700HD remote control, which will learn the new command.

Programming a Command

1Place your source remote “head-to-head” with the GFR-700HD remote.

•The two remotes should be in line with each other, about 2 to 3 inches apart.

2On the GFR-700HD remote, press the applicable Source and Select buttons simultaneously.

•The orange status LED and the Source button glow and remain lit.

3On the GFR-700HD remote, press the button to be taught.

• The orange status LED begins flashing.

4On the Source remote control, press and hold the button to be copied.

•The green status LED glows and remains lit. 5 Release the button on the Source remote con-

trol.

•The orange status LED begins flashing again. 6 Press the button on the Source remote control a

second time.

•The green status LED blinks twice and then goes back to steady orange to indicate that the command has been saved.

•Repeat steps 4~6 for any other commands you want to teach your GFR-700HD remote for that Source component.

7Press the Source and Select buttons simultane- ously to save.

•The orange status LED blinks twice and turns off.

Chapter 3 - Setup

Status LED (Orange/Green/Red)

Source buttons

Select button

50GFR-700HD Owner’s Manual