Graco 70 owner manual Using Child Restraint with Built-in Harness

Page 29

10.0 Using Child Restraint WITH Built-in Harness

FAILURE TO PROPERLY ADJUST THE HARNESS STRAPS

FOR YOUR CHILD INCREASES THE RISK OF SERIOUS

INJURY OR DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP OR CRASH. Snugly adjust the belts provided with this child restraint around your child. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’s flesh or push the child’s body into an unnatural position.

1.Loosen the harness straps by lifting the harness adjuster lever at front of seat near the adjustment strap and pulling the straps toward you .

2.Open harness clip .

29

Image 29

Contents Argos Elite Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of Manufacture Purchase DateSecond Hand Child Restraint Head support side wing buttons FeaturesPage Harness Strap Arm Slot Assembling the Child RestraintClick Page Assembly is now complete ‡ Never Leave Your Child Unattended Page Your child must meet all requirements Height and Weight LimitationsWith Built-In Harness Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ &RPELQDWLRQ/DS6KRXOGHU%HOWZLWK With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking Clip‡ Passive Restraint Lap or Shoulder Belt Mounted on Door Unsafe Vehicle Belt Systems‡ Lap Belts with Emergency Locking Retractor ELR ‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Unbuckle harness straps œ Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltTighten vehicle seat belt Safety Check for Secure Installation Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡Avoid bulky clothing Securing Your Child in the Child RestraintPage MXVWDERYHWKHVKRXOGHUV œ Harness straps must be even with orAdjusting Head Support/Harness Straps To prevent serious injury or death Check Harness SystemTo use without built in harness Remove harness straps Harness RemovalPage Page Keep Gutters Clear Page Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode 7RDGMXVWKHDGVXSSRUWVLGHZLQJV Removing Back Support Page Page Page Page Rear View of Child Sitting in Seat Correct Incorrect š › Using the TetherStoring Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot ™ › ž œCare and Maintenance To Remove Head Support and Seat Covers Head Support Cover clean with a dampHook and loop