Graco 70 owner manual With Latch, Lay flat and not be twisted

Page 35

11.3 With LATCH

	Use vehicle belt (not LATCH connectors) for
	installations with children weighing more than
	48 pounds (21.7 kg). NOTE: Some vehicle
	manufacturers have lower maximum weight
	ratings for LATCH anchors, so you must
	consult your vehicle owner’s manual or call the
	vehicle manufacturer to confirm the limits on your
	vehicle’s LATCH anchors.
	1. Unhook LATCH from storage bars on the
	sides of the seat. For ease of installation, extend
	LATCH to its maximum length.
	2. Place the child restraint firmly against the back
	of a forward-facing vehicle seat.
	3. Hook LATCH Connectors to vehicle lower
	anchors . Pull firmly on Connectors
	to be sure they are attached. Belt must
	lay flat and not be twisted.
	4. Tighten LATCH by pushing down hard on
	4. Tighten LATCH by pushing down hard on
	child restraint and pulling the adjustment belt .
	5. If you need to remove LATCH to readjust,
	push button on LATCH buckle to loosen strap.
	35

Image 35

Contents Argos Elite Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of Manufacture Purchase DateSecond Hand Child Restraint Head support side wing buttons FeaturesPage Harness Strap Arm Slot Assembling the Child RestraintClick Page Assembly is now complete ‡ Never Leave Your Child Unattended Page Your child must meet all requirements Height and Weight LimitationsWith Built-In Harness Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ &RPELQDWLRQ/DS6KRXOGHU%HOWZLWK With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking Clip‡ Passive Restraint Lap or Shoulder Belt Mounted on Door Unsafe Vehicle Belt Systems‡ Lap Belts with Emergency Locking Retractor ELR ‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Unbuckle harness straps œ Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltTighten vehicle seat belt Safety Check for Secure Installation Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡Avoid bulky clothing Securing Your Child in the Child RestraintPage MXVWDERYHWKHVKRXOGHUV œ Harness straps must be even with orAdjusting Head Support/Harness Straps To prevent serious injury or death Check Harness SystemTo use without built in harness Remove harness straps Harness RemovalPage Page Keep Gutters Clear Page Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode 7RDGMXVWKHDGVXSSRUWVLGHZLQJV Removing Back Support Page Page Page Page Rear View of Child Sitting in Seat Correct Incorrect š › Using the TetherStoring Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot ™ › ž œCare and Maintenance To Remove Head Support and Seat Covers Head Support Cover clean with a dampHook and loop