Graco 70 owner manual Storing Lower Anchors and Tether Latch

Page 61

21.1 Storing Lower Anchors and Tether (LATCH)

1.For ease of storing, extend LATCH to its maximum length.

2.Locate the storage bars on back of

child restraint ™.

3.Fasten ends of tether and lower anchors onto their respective storage bars as shown

š.

4.Tether and lower anchors storage should look like this when complete š.

™

Tether

Lower anchors

Storage bars located on each side at the back of the seat

š

Lower anchors

61

Image 61
Contents Argos Elite Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of Manufacture Purchase DateSecond Hand Child Restraint Head support side wing buttons FeaturesPage Harness Strap Arm Slot Assembling the Child RestraintClick Page Assembly is now complete ‡ Never Leave Your Child Unattended Page With Built-In Harness Height and Weight LimitationsYour child must meet all requirements Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ &RPELQDWLRQ/DS6KRXOGHU%HOWZLWK With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking Clip‡ Lap Belts with Emergency Locking Retractor ELR Unsafe Vehicle Belt Systems‡ Passive Restraint Lap or Shoulder Belt Mounted on Door ‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Unbuckle harness straps œ Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltTighten vehicle seat belt Safety Check for Secure Installation Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡Avoid bulky clothing Securing Your Child in the Child RestraintPage MXVWDERYHWKHVKRXOGHUV œ Harness straps must be even with orAdjusting Head Support/Harness Straps To prevent serious injury or death Check Harness SystemTo use without built in harness Remove harness straps Harness RemovalPage Page Keep Gutters Clear Page Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode 7RDGMXVWKHDGVXSSRUWVLGHZLQJV Removing Back Support Page Page Page Page Rear View of Child Sitting in Seat Correct Incorrect š › Using the TetherStoring Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot ™ › ž œCare and Maintenance To Remove Head Support and Seat Covers Head Support Cover clean with a dampHook and loop