Graco 70 owner manual Harness straps must be even with or, MxvwDeryhWkhVkrxoghuv œ

Page 39

5.The harness straps must be even with or

MXVWDERYHWKHVKRXOGHUV œ.

To adjust head support/harness strap height see page 40.

6.Make sure straps are flat and snug against child’s shoulders and thighs. You should not be able to pinch  the harness straps. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’s flesh or push the child’s body into an unnatural position.

CHECK that child’s ears are BELOW top of head support. If tops of ears are above top of head support, child is too large for harnessed use.

œ



39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Argos Elite Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of Manufacture Purchase DateSecond Hand Child Restraint Head support side wing buttons FeaturesPage Harness Strap Arm Slot Assembling the Child RestraintClick Page Assembly is now complete ‡ Never Leave Your Child Unattended Page Height and Weight Limitations With Built-In HarnessYour child must meet all requirements Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ &RPELQDWLRQ/DS6KRXOGHU%HOWZLWK With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking ClipUnsafe Vehicle Belt Systems ‡ Lap Belts with Emergency Locking Retractor ELR‡ Passive Restraint Lap or Shoulder Belt Mounted on Door ‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Unbuckle harness straps œ Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltTighten vehicle seat belt Safety Check for Secure Installation Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡Avoid bulky clothing Securing Your Child in the Child RestraintPage MXVWDERYHWKHVKRXOGHUV œ Harness straps must be even with orAdjusting Head Support/Harness Straps To prevent serious injury or death Check Harness SystemTo use without built in harness Remove harness straps Harness RemovalPage Page Keep Gutters Clear Page Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode 7RDGMXVWKHDGVXSSRUWVLGHZLQJV Removing Back Support Page Page Page Page Rear View of Child Sitting in Seat Correct Incorrect š › Using the TetherStoring Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot ™ › ž œCare and Maintenance To Remove Head Support and Seat Covers Head Support Cover clean with a dampHook and loop
Top Page Image Contents