Briggs & Stratton 073002 Engine Technical Information, Product Specifications, Power Ratings

SPECIFICATIONS

ENGINE TECHNICAL

INFORMATION

These water pumps are powered by a single cylinder, overhead valve(OHV), air cooled, low emissions engine.

In the State of California, these water pump engines are certified by the California Air Resources Board to meet emissions standards for 250 hours. Such certification does not grant the purchaser, owner or operator of this engine any additional warranties with respect to the performance or operational life of this engine.The engine is warranted as stated elsewhere in this manual.

Power Ratings

The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002-05). Given both the wide array of products on which our engines are placed, and the variety of environmental issues applicable to operating the equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a piece of power equipment (actual “on-site” power).This difference is due to a variety of factors including, but not limited to, the following: differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication, maximum governed engine speed, individual engine to engine variability, design of the particular piece of power equipment, the manner in which the engine is operated, engine run-in to reduce friction and clean out of combustion chambers, adjustments to the valves and carburetor, and other factors.The power ratings may also be adjusted based on comparisons to other similar engines utilized in similar applications, and will therefore not necessarily match the values derived using the foregoing codes.

PRODUCT

SPECIFICATIONS

Model 073001

Water Pump Specifications
Suction Port Diameter	2 in (50 mm)
Discharge Port Diameter	2 in (50 mm)
Total Head	106 ft (32 m)
Maximum Head
Suction Lift	. . 25 ft (8 m)
Discharge Lift	. 81 ft (25 m)

Maximum Discharge Capacity . 155 US gal (586 l) per minute

Shipping Weight	. . . . . . . . . . . . . . . . . . . . . 127 lbs.
Engine Specifications
Rated Horsepower	. . . . . . . . . . . . . . 5.5 at 3600 rpm
Bore	. . . . . . . . . . . . . . 2.69 in. (68mm)
Stroke	. . . . . . . . . . . . . . 2.20 in. (56mm)
Displacement	. . . . . . . . . . . . . 12.48 in. (206 cc)
Spark Plug
Type:	Champion RC12YC or Equivalent
Set Gap To:	. . . . . . . . . . . 0.030inch (0.76mm)
Armature Air Gap:	. . . . . . . . . . . . . . . 0.010-0.014 in.
	(0.25-0.36mm)

Valve clearance with valve springs installed and piston 1/4 in.

(6 mm) past top dead center of compression stroke (check when

engine is cold).
Intake	0.004-0.006 in.
	(0.10-0.15 mm)
Exhaust	0.009-0.011 in.
	(0.23-0.28 mm)
Fuel Capacity	. 1 U.S. gallons

Oil Capacity . . . . . . . . . . . . . . . . . . . .20 Ounces (.6 Liters) Oil Type:

Above 40° F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .SAE 30 Below 40° F . . . . . . . . . . . . . . . . .SAE 5W-30 or 10W-30

NOTE: For practical operation, the horsepower loading should not exceed 85% of rated horsepower. Engine power will decrease 3-1/2% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F (5.6° C) above 77° F (25° C). It will operate satisfactorily at an angle up to 15°.

15