TROUBLESHOOTING

TROUBLESHOOTING

Problem

Cause

Correction

 

 

 

 

 

 

1.

Pump not primed.

1.

Fill pump chamber with water and

 

 

 

 

prime pump.

 

2.

Suction hose restricted, collapsed,

2.

Replace suction hose.

 

 

damaged, too long, or diameter too

 

 

 

 

small.

 

 

 

3.

Strainer not completely under water.

3.

Sink the strainer and the end of

 

 

 

 

suction hose completely under water.

No pump output or low

4.

Air leak at suction hose connector.

4.

Replace sealing washer if missing or

pump output when water

 

 

 

damaged.Tighten hose connector and

pump is running.

 

 

 

clamp.

 

5.

Strainer clogged.

5.

Clean debris from strainer.

 

6.

Discharge hose restricted, damaged, too

6.

Replace discharge hose.

 

 

long, or diameter too small.

 

 

 

7.

Excessive or marginal head.

7.

Relocate pump and/or hoses to

 

 

 

 

reduce head.

 

8.

Engine speed lever is in “Slow” position.

8.

Move engine speed lever to “Fast

 

 

 

 

position.

 

 

 

 

 

 

1.

Rocker switch set to "Off".

1.

Set switch to "On".

 

2.

Fuel valve is in "Off" position.

2.

Turn fuel valve to "On" position.

 

3.

Dirty air cleaner.

3.

Clean or replace air cleaner.

 

4.

Out of fuel.

4.

Wait two minutes and fill fuel tank.

 

5.

Stale or contaminated fuel or water in

5.

Drain fuel tank and carburetor; fill

 

 

fuel.

 

with fresh fuel.

Engine will not start; lacks

6.

Spark plug wire not connected to spark

6.

Connect wire to spark plug.

 

plug.

 

 

power; starts and runs

 

 

 

7.

Bad spark plug.

7.

Replace spark plug.

rough; or "hunts" or falters.

 

8.

Excessive fuel is present in the air/fuel

8.

Wait 5 minutes and re-crank engine.

 

 

mixture causing a “flooded” condition.

 

 

 

9.

Excessively rich fuel mixture.

9.

Contact Authorized service facility.

 

10.

Intake valve stuck open or closed.

10.

Contact Authorized service facility.

 

11.

Engine has lost compression.

11.

Contact Authorized service facility.

 

12.

Carburetor is running too rich or too

12.

Contact Authorized service facility.

 

 

lean.

 

 

 

 

 

 

 

Engine shuts down when

Out of gasoline.

Wait two minutes and fill fuel tank.

running.

 

 

 

 

 

 

 

 

 

22

Page 22
Image 22
Briggs & Stratton 073001, 073002, 073003 owner manual Troubleshooting, Problem Cause Correction