Graco 70 owner manual To Install Locking Clip, Repeat above steps until secure 2 1.25 cm

8.6 To Install Locking Clip

1.Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the shoulder belt.

2.While pushing down on seat, pinch the two straps together behind the buckle tongue. Unbuckle the belt without allowing it to slip.

3.Attach locking clip to lap and shoulder belts as shown ™.

4.Re buckle belt. Check that lap belt does not move by pulling hard. If belt loosens or lengthens, repeat procedure.

Remove locking clip when not using child restraint. Store under it’s tab on the rear of seat.

Test installation to see if child restraint is secure.

If not secure, additional belt tightening may be required:

‡Unbuckle vehicle seat belt.

‡Hold belts together and remove locking clip.

‡Shorten length of lap belt portion slightly by pulling belt through latch plate. Re-attach locking clip.

‡Buckle vehicle seat belt. Press child restraint further down into vehicle seat cushion to help buckle vehicle seat belt. Test installation to see if child restraint is secure. If not secure,

repeat above steps until secure. 23

™

12” (1.25 cm)