Graco 70 owner manual Adjusting Head Support in Booster Mode

Page 51

18.0 Adjusting Head Support in Booster Mode

	BEFORE adjusting the head support height,
	have your child lean forward slightly.
	have your child lean forward slightly.
	Squeeze the red adjustment handle on
	top of seat and pull back support up until it
	snaps into one of the 5 height positions .

To lower, squeeze red adjustment handle and push down.

CHECK to make sure it is securely snapped into one of the 5 height positions by pulling up on head support.

The shoulder belt guides should be even with or just above the shoulders as shown by dotted line . From that position adjust head support, one position, up or down as needed to get a better ¿t.

51

Image 51

Contents Argos Elite Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of Manufacture Purchase DateSecond Hand Child Restraint Head support side wing buttons FeaturesPage Harness Strap Arm Slot Assembling the Child RestraintClick Page Assembly is now complete ‡ Never Leave Your Child Unattended Page Height and Weight Limitations With Built-In HarnessYour child must meet all requirements Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ &RPELQDWLRQ/DS6KRXOGHU%HOWZLWK With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking ClipUnsafe Vehicle Belt Systems ‡ Lap Belts with Emergency Locking Retractor ELR‡ Passive Restraint Lap or Shoulder Belt Mounted on Door ‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Unbuckle harness straps œ Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltTighten vehicle seat belt Safety Check for Secure Installation Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡Avoid bulky clothing Securing Your Child in the Child RestraintPage MXVWDERYHWKHVKRXOGHUV œ Harness straps must be even with orAdjusting Head Support/Harness Straps To prevent serious injury or death Check Harness SystemTo use without built in harness Remove harness straps Harness RemovalPage Page Keep Gutters Clear Page Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode 7RDGMXVWKHDGVXSSRUWVLGHZLQJV Removing Back Support Page Page Page Page Rear View of Child Sitting in Seat Correct Incorrect š › Using the TetherStoring Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot ™ › ž œCare and Maintenance To Remove Head Support and Seat Covers Head Support Cover clean with a dampHook and loop