Kidco G170 manual Introduction, Product Information, Extension Placement Guide

Introduction

ENG FOLLOWThe gate must be installed inTHESEa structurally sound

INSTRUCTIONSopening. Never install between two railings or two stair posts. Ensure mounting surface (wall, doorframe, CAREFULLYstair post, etc.) is strong, rigid and isANDsmooth, clean KEEPand grease free. THEM FOR

If mounting onto brick, drywall or other surfaces, FUTUREan optional gate installation kit, wooden board mounted to the surface or additional hardware may REFERENCEbe necessary to provide a solid, smoother surface.

ThisMeasuregateopeningis designedto determfor chineldrenif extensionsfrom 6 monthsare to 24 monthsneeded. Since each child’s skills develop at different

ages, these parameters should be monitored against Correct width will be reached by adjust ng all 4 your child’s own development.

corner spindles. Each spindle adjusts individually and

may be extended to varying lengths (up to 2” each) When installed as instructed, between two clean structurallyto allow for soundmolding,surfaces,uneventhiswalls,gateetcconforms. If using to:gate

ASTMon a stairway, itF-must1004-be07placUnited onStatesthe lowestStandardsstair on bottom.

Spindle attachment is different when using extensions and when not using extensions. If no

extension/s are used, insert spindle housings (D)

WARNING

sand)NTENDEDspindlesFOROUSESWITH(B and C) asCHILDRENshownFROM. MONTHS

through 24 months.

If using extension/s (see Extension Placement Guide) s #HECKETHEHSTABILITYIOF THEHGATE ANDNTIGHTENHALLL insert square extension tubes (H) into gate ends.

hardware and mountings regularly. Connect

s 4OOPREVENTESERIOUSIINJURY OR DEATH SECURELYLINSTALLT extension bar (G) to one upper extension housing (E)

gate or enclosure and use according to andmanufacturer’so lower extensioninstructionshousing. (F). Push assembly

sover.EVERVUSESWITHextension tubesAACHILDIABLE(H). ThereTOshouldCLIMBIOVERbe noORmetal

dislodge/open the gate or enclosure.

showing from extension tubes. It may be necessary to

s.EVERVUSESIF GATE IS LESS THAN OF CHILDSSHEIGHT apply pressure to tubes to ensure they are fully

s$O NOTOUSESIF ANYNPART OF THEHGATE IS BROKEN OR MISSING inserted

sinto4HISgatePRODUCTUWILLends. SlideNOTONECESSARILYSPREVENTEALLLspindles into extension tubes.

accidents. Never leave child unattended.

Open the handle to the raised position by pressing s 5SESONLY SPAREEPARTSRAVAILABLELFROM +ID#O buttons (1) on both sides of gate at the same time s .EVERVALLOWLCHILDITO CLIMBIOR SWINGION GATE and lifting handle (2). BUTTONS MUST ALWAYS BE s 5SESONLY WITH THEHLOCKINGLATCHING MECHANISMA PRESSED IN WHEN LIFTING HANDLE. FAILURE

securely engaged.

sTO.DOEVERVUSESGATESO WILL RESULTAT TOPOOFINSTAIRSHANDLE MECHANISM

sBREAKI$ISCONTINUENUSESIFG. ANYNPART OF GATE IS DAMAGED

Disengage.EVERVCLIMBIOVERtension leverTHEHGATEby pressing in on right side (1)

s.EVERVHANG OR TIEITOYS ETC TO ANYNPART OF THEHGATE and lifting up (2).

Product Information

sCenter.O PARTgateOFinGATEopeningREQUIRESwithLUBRICATIONbottom rail resting on

sfloor#LEANEUSINGIWARM. Gaps on each sideRSOAPYAWATERTORshould be equalAADAMP. PullCLOTHout all s $O NOTOUSESABRASIVE CLEANERS OR BLEACH

sfour)F USINGIOUTDOORSspindles until theyOANDNTOtouchHELPmountingPREVENTERUSTsurfaceSTREATAand

gate with a rust inhibitor.

bottom spindles rest on top of floor molding (if Some rusting may still occur.

applicable).

s /NCE INSTALLEDATHEHGATE SHOULD BE CHECKEDC Loosely tighten nuts TOWARD GATE FRAME

periodically to ensure a safe and secure fit and on all 4 spindles.

to maintain proper working order.

Tighten bottom spindle nuts as tightly as possible.

Extension Placement Guide

Engage tension lever by pressing lever down (1) and

pulling out tab (2).

G5170.5 -Extension5.5 ExtensionPlacementPlacementGuideGuidefor Metrofor MetroGatewayGateway(Model(ModelG170)G170) Note: Each%ACH G170'-5.5 Extension%XTENSIONN+ITICONTAINSKit contains two extensions

Width Opening				Extensions
29” – 31 ½”				Basic Gate
vnn–	 žv			"ASICS'ATE
31 ½” - 34 ½”				Included with Gate
 žv -			žv	)NCLUDEDcl ed WITH 'ATE
34 ½” – 37”
 žv nn–		v
vnn–	v			-'- . kitIT
37” –	40”			1-G170-5.5 Kit
40” – 42 ½”
vnn–	 žv
 žv nn–		v		-'- . kitsITS
42 ½” –		45”		2-G170-5.5 Kits
45” – 47 ½”
vnn–	 žv

What You Need No.O extensionsEXTENSIONSsi s Gate'ATE +1 extensionEXTENSIONsi Gate'ATE +2 extensionsEXTENSIONSsi s

Gate'ATE +3 extensionsEXTENSIONSsi s Gate'ATE +4 extensionsEXTENSIONSsi s

Gate'ATE +5 extensionsEXTENSIONSsi s Gate'ATE +6 extensionsEXTENSIONSsi s

Placement

-1 onON oneONENENDend

-

-1 onON eachEACH endEND

-

-2 onON oneONENENDend;; 1onON otherOTHERHENDer end

-

-3 on each end; 1 on other end
-2	ON EACH END	2 on other end
-3 on one end;
-	ON ONENEND;	ON OTHERHENDer
-3 on each end
-	ON EACH END

Each end may have no more than 3 extensions.

4Extensions must be added as shown.