Installation
6.Pull out the two bottom spindles (s) until they touch mounting surface and rest on top of floor molding
(if applicable). Tighten handwheels TOWARD GATE FRAME as tightly as possible. Each spindle adjusts individually and may be extended to varying lengths to allow for molding, uneven walls, etc.
IMPORTANT: If gate is properly tightened the yellow and red pressure indicators will be absent (6a). If the RED pressure indicator is present further tightening is required (6b). If yellow is still present, gate installation is acceptable but additional tightening is encouraged (6c).
7.Close walk through door so locator (l) is aligned directly above bottom gate rail. Do not lower handle.
Pull out the top spindle (b) on the hinge side (m) until it touches the mounting surface. Tighten handwheel TOWARD GATE FRAME until locator drops and rests on bottom gate rail.
8.Pull out spindle (b) in the handle side until it touches mounting surface and tighten handwheel TOWARD GATE FRAME so the distance between pressure plate
(o) and pressure hinge (area A) is sufficient for walk through door to open in either direction.
9.IMPORTANT: There is a pressure indicator on the handle. If gate is properly tightened yellow and red indicators will be absent (9a). If RED is present further tightening is required (9b). If yellow is still present, gate installation is acceptable but additional tightening is encouraged (9c).
Operation
10. To Open Gate.
Release locking mechanism by pressing buttons (r) in while lifting handle. BUTTONS MUST ALWAYS BE PRESSED IN WHEN LIFTING HANDLE. Lift walk through door so hinge is raised and door will swing open in either direction.
To Close Gate.
Lift walk through door. Position locator (l) until it is above the bottom rail. Make sure hinge has dropped down. Push handle down to lock.
Gate should always be in locked position when in use.
Warranty
11. Installation aid
KidCo has available OPTIONAL Y spindles (Model
No more than 2 Y spindles may be used per gate and both must be used on the same side.
KIDCO LIMITED WARRANTY
Your KidCo product is warranted to be free from manufacturing defects for a period of one year from date of purchase under normal non commercial use and in compliance with the operating instructions. This warranty extends only to the original retail purchaser and is only valid when supplied with proof of purchase.
KidCo will either repair, or at our option replace, free of charge, any parts necessary to correct defects in material or workmanship during the warranty period. This warranty is complete and exclusive. The warranty expressly disclaims liability for incidental, special and consequential damages of any nature. Any implied warranty arising by operation of law shall be limited in operation to the terms of this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
SHOULD REPAIR OR PARTS BE NECESSARY
Should a repair be needed during the warranty period, ship the gate in the original carton or similar protective container (check any retail store or purchase from UPS) and send freight prepaid (we suggest UPS) to:
KidCo, Inc., 1013 Technology Way, Libertyville, IL 60048-5349.
Include a note with your return address,
6