Apollo 1650ETL, 1550ETL installation manual Off

Page 16

Program Switches

 

 

OFF

ON

1

TIMER TO CLOSE

Gate does not automatically close.

Gate automatically closes.

2

TIMER TO CLOSE OPT.

Gate automatically closes from

Gate automatically closes only when completely

 

 

any position after opening.

open (open limit engaged).

3

SLAVE DISABLE

Enables slave side (dual gate use).

Disables slave side. (single gate use)

4

SIREN DELAY

Siren (optional) active when gate is

Siren (optional) starts 5 seconds before gate moves.

 

 

moving.

 

5

‘STOP’ CIRCUIT ENABLE

Must hold down open or close

Normal operation

 

 

buttons to move gate. Gate stops

Momentary open or close input runs gate to limit.

 

 

when button released.

 

6

LOCK TYPE

For 12V mechanical (solenoid) locks.

For 12V magnetic locks.

 

 

(+12V for 4 seconds on open cycle)

(+12V when on close limit)

7

COAST ENABLE

Gate will stop immediately when at

Gate will coast (minimally) when it reaches limits.

 

 

Open or Close limit

Recommended for 7500 slide operator only.

8

FREE EXIT OPT.

A free exit input will open gate from

A free exit input will open gate from any

 

 

closed position or after a close cycle

position after an open or close cycle.

 

 

only.

 

9 DUAL GATE SYNC

Both gates operate at normal

 

Speed (slave slower than

 

Master).

This feature will control the master gate to open or close at the same speed as the slave gate.

10 SMART ACT.

Off for 416E & 416EX actuators,

Used for 816E & 816EX actuators only

 

slide gates, 3500 or when slow down

(soft start & stop).

 

feature is not desired.

 

 

16

 

Image 16
Contents Installation Manual Contents Important Safety Instructions Applications PRE-INSTALLATION Checklist Consider safety and access options. Recommend if neededParts Identification OptionsVertical position Location of Pivot PointPivot arm Connecting the Actuator s Gate Bracket Installation 1550ETL / 1650ETL Actuator Option Push to Open Installation Rewiring actuator s for push to openTop View Pivot arm sProgramming Instructions 835/836 Control Board Parts Identification GateLink Connector Adjustments Push Buttons Jumpers OFF Optional Device Inputs Apollo Gate Operators, Inc Apollo Gate Operators Receiver Options Symptom Gate moves only a few feet, then stops or reverses Symptom Gate opens OK but after closing, opens back upSymptom Gate surges too much. Does not run smooth Symptom Transmitter works, but not very far Symptom Gate randomly opens, closes, or stops for no reasonSymptom Gate will not open or close Dual BoardsLimited TWO-YEAR Warranty