Apollo 1550ETL, 1650ETL installation manual Apollo Gate Operators Receiver Options

Page 19

APOLLO Gate Operators RECEIVER OPTIONS

Do not confuse the receiver code switches with the red program switches on the gate control board.

Never set all code switches to the same position. Transmitters must match code switches for proper operation. If power is taken directly from battery or connected as shown below, receiver should be configured for 12VDC

Multi-Code/Digi-Code

black

gray

gray

red

Allstar

white

black

red

Lift-Master*

1

2

3

4

Heddolf

black

white

yellow

red

Linear

white/silver

common

n/o

white/gold

*Lift-Master will require that the 12/24 jumper be set to 12 and the C/M (constant/momentary) jumper be set to C

19

Image 19
Contents Installation Manual Contents Important Safety Instructions Applications Consider safety and access options. Recommend if needed PRE-INSTALLATION ChecklistOptions Parts IdentificationVertical position Location of Pivot PointPivot arm Connecting the Actuator s Gate Bracket Installation 1550ETL / 1650ETL Actuator Option Pivot arm s Push to Open InstallationRewiring actuator s for push to open Top ViewProgramming Instructions 835/836 Control Board Parts Identification GateLink Connector Adjustments Push Buttons Jumpers OFF Optional Device Inputs Apollo Gate Operators, Inc Apollo Gate Operators Receiver Options Symptom Gate moves only a few feet, then stops or reverses Symptom Gate opens OK but after closing, opens back upSymptom Gate surges too much. Does not run smooth Symptom Gate randomly opens, closes, or stops for no reason Symptom Transmitter works, but not very farDual Boards Symptom Gate will not open or closeLimited TWO-YEAR Warranty