Dantax LR-8500 manual PRE OUT SUB Woofer jack, Power cord AC Input, RS-232C

ZONE II SPEAKER OUTPUTS

Surround Back/ZONE II Speaker Outputs:

These speaker terminals are normally used to power the surround back left/surround back right speakers in a 7.1-channel system. However, they may also be used to power the speakers in a sec- ond zone. which will receive the output selected for a ZONE II SPEAKER system. To change the output fed to these terminals from the default of the Surround Back speakers to the ZONE II SPEAKER Output, you must change a setting in the ZONE II SETUP of the OSD system. See page 30 for more information on configuring this speak- er output. For ZONE II SPEAKER use, connect the brown and black SBL terminals to the red and black connections on the left remote zone speak- er and connect the tan and black SBR terminals to the red and black terminals on the right remote zone speaker.

ZONE II AUDIO OUTPUT

Connect these jacks to the optional external audio power amplifier and video distribution system that delivers the source selected for ZONE II distribu- tion.

PRE OUT ( SUB WOOFER ) jack

Use this jack to connect a powered sub-woofer or passive sub-woofer with a power amplifier (OPTIONAL) .

Power cord (AC INPUT)

Be sure to connect the power cord to an AC outlet which supplies the correct voltage.

Hold the power plug when plugging or unplugging the power cord.

AC OUTLET (SWITCHED)

This outlet is only active when the receiver is turned on.

Caution:

Make sure that the total power consumption of all equipment connected to the outlets on the receiv- er does not exceed 100 watts.

RS-232C

The RS-232C port may also be used in the future to update the operating software of the LR-8500 so that it will be able to support new digital audio for- mats and the like as they are introduced.