Eddie Bauer Luxe Fasten one Latch belt, For other side of child, Locations and more, Information

4358-3340D Elite_Lux 3/13/06 3:08 PM Page 39

4	Fasten one LATCH belt
	hook to the anchor in the
	vehicle seat located in the
	vehicle seat bight. Repeat
	for other side of child
	restraint. See your vehicle
	owner’s manual for
	locations and more
	information.

7

side is acceptable.

With weakest hand at belt path, tilt and push the child restraint forward and back and side to side. If the seat belts do not loosen, your child restraint should be secure.

NOTE: Some “play” from front to back or an inch or two from side to

Forward-Facing Use: 22-40 lbs.

5

Place one knee in the child restraint and push down firmly while pulling up on the loop to tighten belt.

If the child restraint does not remain tight, do not use the child restraint in this seating location with this LATCH system.

!WARNING

Using this child restraint in any vehicle seat where the LATCH belt cannot be tightened securely and properly or where it can be loosened by pulling on it, can result in serious injury or death.

8	After checking for hot
	seat and buckles, place
	child in child restraint.
	See “Securing Your Child
	in the Child Restraint”
	section.
9	To remove LATCH:

(10.1-18 kg), 34-43” (85.1-110 cm), Over 1 year of

6	With knee still in child
	restraint, attach hook to
	anchor in vehicle. Push
	down firmly and tighten
	top anchorage strap.
	To adjust top anchorage
	strap: See “Adjusting Top
	Anchorage Strap” section.
	36

Remove child from child

restraint. Press down

firmly on adjuster side of

child restraint and press

release button to release

tension. Unhook LATCH

from bar by squeezing

spring lever and twist

hook.

37

age.